Home › SUSPENSION & AXLE › TIRE AND WHEEL › TIRE PRESSURE WARNING SYSTEM

TIRE PRESSURE WARNING SYSTEM > TC and CG Terminal Circuit

for Preparation Click here


DESCRIPTION

DTC output mode is set by connecting terminals 13 (TC) and 4 (CG) of the DLC3. The DTCs are indicated by the tire pressure warning light blinking pattern.

WIRING DIAGRAM


B128089E01

HINT:
If the tire pressure warning light blinks continuously, a ground short in the wiring of terminal TC of the DLC3 or an internal ground short in each ECU is suspected.


INSPECTION PROCEDURE

1.CHECK HARNESS AND CONNECTOR (DLC3 - ECM AND BODY GROUND)


    B128090E01
  1. Disconnect the E6 hybrid vehicle control ECU connector.

  1. Measure the resistance according to the value(s) in the table below.

    Standard resistance:
    Tester Connection
    Condition
    Specified Condition
    D1-13 (TC) - E6-14 (TC)
    Always
    Below 1 Ω
    E6-14 (TC) - Body ground
    Always
    10 kΩ or higher
    D1 (CG) - Body ground
    Always
    Below 1 Ω



NG
REPAIR OR REPLACE HARNESS OR CONNECTOR
OK


2.INSPECT DLC3 (TC VOLTAGE)


    H100769E70
  1. Measure the voltage according to the value(s) in the table below.

    Standard voltage:
    Tester Connection
    Switch Condition
    Specified Condition
    D1-13 (TC) - Body ground
    Power switch on (IG)
    11 to 14 V



NG
REPLACE ECM (Click here)
OK

PROCEED TO NEXT CIRCUIT INSPECTION SHOWN IN PROBLEM SYMPTOMS TABLE (Click here)