Home › ENGINE › 1NZ-FXE ENGINE CONTROL SYSTEM › ECM

ECM > REMOVAL

for Preparation Click here



1. DISCONNECT CABLE FROM NEGATIVE BATTERY TERMINAL

CAUTION:
Wait at least 90 seconds after disconnecting the cable from the negative (-) battery terminal to prevent airbag and seat belt pretensioner activation.



2. REMOVE INSTRUMENT PANEL SUB-ASSEMBLY
  1. Remove the instrument panel (Click here).



3. REMOVE NO. 3 HEATER TO REGISTER DUCT


    I038566E01
  1. Remove the clip and No. 3 heater to register duct with the No. 2 side defroster nozzle duct.



4. REMOVE ECM


A087532E01
  1. Disconnect the 4 ECM connectors.

  1. Disconnect the 4 hybrid vehicle control ECU connectors.



    A087535E01
  1. Remove the 2 nuts and bolt, and ECM with bracket.



    A087475E01
  1. Remove the 2 nuts and ECM.



    A087476E01
  1. Remove the 6 screws and 3 No. 1 ECM brackets.



    A087477E01
  1. Remove the 4 screws and 2 No. 2 ECM brackets.



    A087478E01
  1. Remove the 2 screws and No. 3 ECM bracket.