Home › RESTRAINTS › SUPPLEMENTAL RESTRAINT SYSTEM › AIRBAG SYSTEM

DTC    B1000/31    Center Airbag Sensor Assembly Malfunction

for Preparation Click here


DESCRIPTION

The center airbag sensor consists of the airbag sensor, the safing sensor, the drive circuit, the diagnosis circuit and the power control.
When the center airbag sensor receives signals from the airbag sensor, it determines whether or not the SRS should be activated.
DTC B1000/31 is set when a malfunction is detected in the center airbag sensor.

DTC No.
DTC Detection Condition
Trouble Area
B1000/31
Center airbag sensor malfunction
Center airbag sensor

HINT:
When any other DTCs are set simultaneously with B1000/31, repair the malfunctions indicated by those DTCs first.


INSPECTION PROCEDURE

1.CHECK CENTER AIRBAG SENSOR ASSEMBLY


    H041086E03
  1. Turn the power switch OFF.

  1. Disconnect the cable from the negative (-) battery terminal, and wait for at least 90 seconds.

  1. Connect the cable to the negative (-) battery terminal, and wait for at least 2 seconds.

  1. Turn the power switch ON (IG), and wait for at least 60 seconds.

  1. Clear the DTCs (Click here).

  1. Turn the power switch OFF.

  1. Turn the power switch ON (IG), and wait for at least 60 seconds.

  1. Check for DTCs (Click here).

    OK:
    DTC B1000/31 is not output.



NG
REPLACE CENTER AIRBAG SENSOR ASSEMBLY
OK

USE SIMULATION METHOD TO CHECK