NAVIGATION SYSTEM > HOW TO PROCEED WITH TROUBLESHOOTING |
| 1.VEHICLE BROUGHT TO WORKSHOP |
| |||||
| 2.INSPECT BATTERY VOLTAGE |
| |||||
| 3.BASIC INSPECTION |
Turn the power switch ON (ACC).
Check whether or not the display appears on the multi-display.
| Result | Proceed to |
| Display appears | A |
| Display does not appear | B |
|
| ||||
| |||||
| 4.INSPECT COMMUNICATION FUNCTION OF MULTIPLEX COMMUNICATION SYSTEM (BEAN)* |
Use the Techstream to check if the Multiplex Communication System (MPX) is functioning normally.
| Result | Proceed to |
| MPX DTC is not output | A |
| MPX DTC is output | B |
|
| ||||
| |||||
| 5.CHECK FOR DTC |
Check for DTCs and note any codes that are output.
Delete for DTC.
Recheck for DTCs. Based on the DTC output in the first step, try to force output of the audio system DTC by simulating the operation indicated by the DTC.
| Result | Proceed to |
| DTC does not reoccur | A |
| DTC does not reoccurs | B |
|
| ||||
| |||||
| 6.PROBLEM SYMPTOMS TABLE |
| Result | Proceed to |
| Fault is not listed in problem symptoms table | A |
| Fault is listed in problem symptoms table | B |
|
| ||||
| |||||
| 7.OVERALL ANALYSIS AND TROUBLESHOOTING |
Terminals of ECU (Click here)
| |||||
| 8.ADJUST, REPAIR OR REPLACE |
|
| ||||
|---|---|---|---|---|---|