Home › BODY ELECTRICAL › PARK ASSIST / MONITORING › REAR VIEW MONITOR SYSTEM

REAR VIEW MONITOR SYSTEM > HOW TO PROCEED WITH TROUBLESHOOTING

for Preparation Click here


HINT:
Use theses procedures to troubleshoot the rear view monitor system.



1.VEHICLE BROUGHT WORKSHOP

    NEXT


    2.INSPECT BATTERY VOLTAGE

      Standard voltage:
      11 to 14 V

      If the voltage is below 11 V, recharge or replace the battery before proceeding.

    NEXT


    3.CHECK CAMERA LENS
    1. Check that the camera lens is not dirty with mud, foreign matter, etc.


    NEXT


    4.BASIC INSPECTION
    1. Turn the power switch ON (ACC).

    2. Check whether or not the display appears on the multi-display.
      Result 
      Result
      Proceed to
      Display appears
      A
      Display does not appear
      B



    B.
    Go to NAVIGATION SYSTEM
    A


    5.PROBLEM SYMPTOMS TABLE
      Result 
      Result
      Proceed to
      Fault is not listed in problem symptoms table
      A
      Fault is listed in problem symptoms table
      B


    B.
    Go to step 7
    A


    6.OVERALL ANALYSIS AND TROUBLESHOOTING
    1. Terminals of ECU (Click here)


    NEXT


    7.ADJUST, REPAIR OR REPLACE

      NEXT

      END