COOLANT (for Engine) > ON-VEHICLE INSPECTION |
| 1. REMOVE RADIATOR SUPPORT OPENING COVER |
![]() |
Remove the 6 clips and radiator support opening cover.
| 2. REMOVE ENGINE UNDER COVER LH |
| 3. REMOVE FRONT FENDER LINER LH |
Remove the front part of the front fender liner LH.
| 4. DRAIN ENGINE COOLANT (for Engine) |
Disconnect the coolant heat storage water pump connector.
Connect a vinyl hose to the drain cock of the radiator.
Connect a vinyl hose to the drain cock of the engine.
Connect a vinyl hose to the drain cock of the coolant heat storage tank.
Loosen the drain cock plugs of the radiator, engine and coolant heat storage tank, then drain the coolant.
Remove the radiator cap.

Drain the coolant in the radiator reservoir.
| 5. ADD ENGINE COOLANT (for Engine) |
Tighten the drain cock plug of the coolant heat storage tank, then disconnect the vinyl hose.
Tighten the drain cock plug of the engine, then disconnect the vinyl hose.
Tighten the drain cock plug of the radiator, then disconnect the vinyl hose.
![]() |
Connect a vinyl hose to the bleeder plug of the radiator assembly and the radiator reservoir.
![]() |
Using a 6 mm socket hexagon wrench, loosen the radiator bleeder plug from the radiator support service hole.
Fill the radiator with coolant up to the fill port.
Using a 6 mm socket hexagon wrench, tighten the radiator bleeder plug.
Install the radiator cop.
Fill the radiator reservoir tank with coolant to the full level.
Connect the coolant heat storage water pump connector.
Connect the Techstream to the DLC3.
Turn the power switch ON (IG).
Select the item:
Powertrain / Engine and ECT / Data List/Activate the Water Pump
![]() |
Using a 6 mm socket hexagon wrench, loosen the radiator bleeder plug from the radiator support service hole.
Remove the radiator cap, then fill the radiator with coolant up to the fill port.
Using a 6 mm socket hexagon wrench, tighten the radiator bleeder plug.
Install the radiator cap.
Slowly pour coolant into the radiator reservoir until it reaches the full line.
Disconnect the vinyl hose between the bleeder plug of the radiator assembly and the radiator reservoir tank.
Set the vehicle to inspection mode (Click here).
Warm up the engine until the thermostat is open.
Stop the engine, then wait until the coolant becomes cold. Remove the radiator cap and check the coolant level.
When the coolant level stops going down, add coolant to the radiator reservoir tank up to the full level.
| 6. INSPECT FOR COOLANT LEAK (for Engine) |
Fill the radiator with engine coolant and attach a radiator cap tester.
Pump the tester to 137 kPa (1.4 kgf/cm2, 19.9 psi) and check for leakage.
| 7. INSTALL FRONT FENDER LINER LH |
| 8. INSTALL ENGINE UNDER COVER LH |
| 9. INSTALL RADIATOR SUPPORT OPENING COVER |
![]() |
Install the opening cover with the 6 clips.