Home › BODY ELECTRICAL › AUDIO / VISUAL › AUDIO AND VISUAL SYSTEM

DTC    01-D5    Absence of Registration Unit

DTC    01-D8    No Response for Connection Check

DTC    01-D9    Last Mode Error

DTC    01-DA    No Response Against ON / OFF Command

DTC    01-DB    Mode Status Error

DTC    01-DE    Slave Reset

for Preparation Click here


DESCRIPTION


DTC No.
DTC Detection Condition
Trouble Area
01-D5
*1, *3
Device that the sub-code shows is (was) disconnected from system when turning power switch ON (ACC or IG).
Communication condition with the device that the code shows cannot be obtained when the hybrid system starts.
  1. Power source circuit of component shown by sub-code
  1. AVC-LAN circuit between multi-display and component shown by sub-code
  1. Component shown by sub-code
01-D8
*2, *3
The device indicated by sub-code is (was) disconnected from the system after the hybrid system starts.
01-D9
*1, *3
Device that had functioned before engine stopped is (was) disconnected from system when the power switch is (was) ON (ACC or IG).
01-DA
*3
No response is identified when changing mode.
Sound and image do not change by switch operation.
01-DB
*1, *3
Dual alarm is detected.
01-DE
*3
Slave device has been disconnected after the hybrid system starts.

HINT:
  1. *1: Even if no fault is present, this trouble code may be stored depending on the battery condition or hybrid system start voltage.
  1. *2: If the power connector is disconnected after the hybrid system starts, this code is stored after 180 seconds.
  1. *3: If the device is reported as not existing during verification, check the power source circuit and AVC-LAN circuit for the device.

NOTICE:
  1. Before starting troubleshooting, be sure to clear DTCs to erase codes stored due to the reasons described in the HINT above. Then, check for DTCs and troubleshoot according to the output DTCs.
  1. The multi-display is the master unit.
  1. Be sure to clear and recheck DTCs after the inspection is completed to confirm that no DTCs are output.


INSPECTION PROCEDURE

NOTICE:
Be sure to read DESCRIPTION before performing the following procedures.

1.CHECK "MULTI-DISPLAY COMMUNICATION ERROR" IN FLOWCHART
  1. Refer to the multi-display communication error (Click here).


NEXT

END