Home › BODY ELECTRICAL › AUDIO / VISUAL › AUDIO AND VISUAL SYSTEM

AUDIO AND VISUAL SYSTEM > Multi-display Communication Error

for Preparation Click here


INSPECTION PROCEDURE

1.IDENTIFY COMPONENT SHOWN BY SUB-CODE


    E107226E01
  1. Enter the diagnostic mode.

  1. Press the "LAN Mon" switch to change to "LAN Monitor" mode.

  1. Identify the component which has stored this code.

    HINT:
    1. "110 (multi-display)" is the component shown by the sub-code in the example shown in the illustration.
    2. The sub-code will be indicated by its physical address.
    3. For details of the DTC display, refer to "DIAGNOSIS DISPLAY DETAILED DESCRIPTION" (Click here).


NEXT


2.CHECK POWER SOURCE CIRCUIT OF COMPONENT SHOWN BY SUB-CODE
  1. Inspect the power source circuit of the component shown by the sub-code.
    If the power source circuit is operating normally, proceed to the next step.

    Component table: 
    Component
    Proceed to
    Gateway ECU (1C6)
    Gateway ECU power source circuit (Click here)
    Stereo component amplifier (440)
    Stereo component amplifier power source circuit (Click here)
    Radio Receiver (190)
    Radio receiver power source circuit (Click here)


NEXT


3.INSPECT RADIO RECEIVER


    E107228E01
  1. for 9 Speaker System:
    Disconnect the R5 and R6 receiver connectors.

  1. for 6 Speaker System:
    Disconnect the R5 receiver connector.

  1. Measure the resistance of the receiver.

    Standard resistance:
    Tester Connection
    Specified Condition
    R5-9 (TX1+) - R5-10 (TX1-)*1
    60 to 80 Ω
    R5-9 (TX+) - R5-10 (TX-)*2
    60 to 80 Ω
    R6-5 (TX+) - R6-15 (TX-)*2
    60 to 80 Ω

    HINT:
    1. *1: for 6 speaker system
    2. *2: for 9 speaker system



NG
REPLACE RADIO RECEIVER
OK


4.CHECK WIRE HARNESS (MULTI-DISPLAY - COMPONENT SHOWN BY SUB-CODE)

HINT:
  1. Start the check from the circuit that is near the component shown by the sub-code first.
  1. For details of the connectors, refer to the "TERMINALS OF ECU" (Click here).



  1. Referring to the AVC-LAN wiring diagram below, check the AVC-LAN circuit between the multi-display and the component shown by the sub-code.

    1. Disconnect all connectors between the multi-display and the component shown by sub-code.



    2. Check for an open or short in the AVC-LAN circuit between the multi-display and the component shown by the sub-code.

      OK:
      There is no open or short circuit.


      E126611E01



NG
REPAIR OR REPLACE HARNESS AND CONNECTOR
OK


5.REPLACE COMPONENT SHOWN BY SUB-CODE
  1. Replace the component shown by the sub-code with a normal one and check if the same problem occurs again.

    OK:
    Same problem does not occur.



NG
REPLACE MULTI-DISPLAY
OK

END