Home › BODY ELECTRICAL › AUDIO / VISUAL › AUDIO AND VISUAL SYSTEM

DTC    01-DD    Master Reset

DTC    01-E1    Voice Processing Device ON Error

for Preparation Click here


DESCRIPTION


DTC No.
DTC Detection Condition
Trouble Area
01-DD
Device that should be master has been disconnected after hybrid system start
  1. Multi-display power source circuit
  1. AVC-LAN circuit between multi-display and component which has stored this code
  1. Multi-display
  1. Component which has stored this code
01-E1
*
AMP device records that AMP output does not function even while source device operates

HINT:
*: Even if no fault is present, this trouble code may be stored depending on the battery condition or hybrid system start voltage.

NOTICE:
  1. Before starting troubleshooting, be sure to clear DTCs to erase codes stored due to the reasons described in the HINT above. Then, check for DTCs and troubleshoot according to the output DTCs.
  1. The multi-display is the master unit.
  1. Be sure to clear and recheck DTCs after the inspection is completed to confirm that no DTCs are output.


INSPECTION PROCEDURE

NOTICE:
Be sure to read DESCRIPTION before performing the following procedures.

1.CHECK MULTI-DISPLAY POWER SOURCE CIRCUIT
  1. Refer to the multi-display power source circuit (Click here).
    If the power source circuit is operating normally, proceed to the next step.


NEXT


2.INSPECT RADIO RECEIVER


    E107228E01
  1. for 9 Speaker System:
    Disconnect the R5 and R6 receiver connectors.

  1. for 6 Speaker System:
    Disconnect the R5 receiver connector.

  1. Measure the resistance of the receiver.

    Standard resistance:
    Tester Connection
    Specified Condition
    R5-9 (TX1+) - R5-10 (TX1-)*1
    60 to 80 Ω
    R5-9 (TX+) - R5-10 (TX-)*2
    60 to 80 Ω
    R6-5 (TX+) - R6-15 (TX-)*2
    60 to 80 Ω

    HINT:
    1. *1: for 6 speaker system
    2. *2: for 9 speaker system



NG
REPLACE RADIO RECEIVER
OK


3.IDENTIFY COMPONENT WHICH HAS STORED THIS CODE


    E107226E01
  1. Enter the diagnostic mode.

  1. Press the "LAN Mon" switch to change to "LAN Monitor" Mode.

  1. Identify the component which has stored this code.
    Component table 
    Display
    Component
    G/W
    Gateway ECU
    DSP-AMP
    Stereo component amplifier
    AUDIO H/U
    Radio Receiver

    HINT:
    "G/W" is the component which has stored this code in the example shown in the illustration.


NEXT


4.CHECK WIRE HARNESS (MULTI-DISPLAY - COMPONENT WHICH HAS STORED THIS CODE)

HINT:
For details of the connectors, refer to the "TERMINALS OF ECU" (Click here).



  1. Referring to the AVC-LAN wiring diagram below, check the AVC-LAN circuit between the multi-display and the component which has stored this code.

    1. Disconnect all connectors between the multi-display and the component which has stored this code.



    2. Check for an open or short in the AVC-LAN circuit between the multi-display and the component which has stored this code.

      OK:
      There is no open or short circuit.


      E126611E01



NG
REPAIR OR REPLACE HARNESS AND CONNECTOR
OK


5.REPLACE MULTI-DISPLAY
  1. Replace the multi-display with a normal one and check if the same problem occurs again.

    OK:
    Same problem does not occur.



NG
REPLACE COMPONENT WHICH HAS STORED THIS CODE
OK

END