Home › RESTRAINTS › SUPPLEMENTAL RESTRAINT SYSTEM › FRONT PASSENGER AIRBAG ASSEMBLY

FRONT PASSENGER AIRBAG ASSEMBLY > REMOVAL

for Preparation Click here


CAUTION:
Be sure to read the precautionary notices concerning the SRS airbag system before servicing it (Click here).



1. DISCONNECT CABLE FROM NEGATIVE BATTERY TERMINAL

CAUTION:
Wait at least 90 seconds after disconnecting the cable from the negative (-) battery terminal to prevent airbag and seat belt pretensioner activation.



2. REMOVE GLOVE COMPARTMENT DOOR ASSEMBLY


B074051E02
  1. While pushing in the sides of the glove compartment door as indicated by the arrows in the illustration, open the door to release it from the 2 stoppers.

  1. Open the door until it is horizontal.



    B074052E02
  1. Pull the glove compartment door toward the rear of the vehicle to detach the 2 hinges and remove the glove compartment door.



3. DISCONNECT PASSENGER AIRBAG CONNECTOR


H043756E02
  1. Disconnect the front passenger airbag connector.

    NOTICE:
    When handling the airbag connector, take care not to damage the airbag wire harness.



4. REMOVE INSTRUMENT PANEL SAFETY PAD
  1. Remove the instrument panel (Click here).



5. DISCONNECT INSTRUMENT PANEL WIRE ASSEMBLY


H043758E03
  1. Disconnect the connectors from the front passenger airbag.

    NOTICE:
    When handling the airbag connector, take care not to damage the airbag wire harness.



6. REMOVE FRONT PASSENGER AIRBAG ASSEMBLY


    C130877
  1. Detach the 10 claws and remove the front passenger airbag.