Home › RESTRAINTS › SUPPLEMENTAL RESTRAINT SYSTEM › CENTER AIRBAG SENSOR ASSEMBLY

CENTER AIRBAG SENSOR ASSEMBLY > INSTALLATION

for Preparation Click here


CAUTION:
Be sure to read the precautionary notices concerning the SRS airbag system before servicing it (Click here).



1. INSTALL CENTER AIRBAG SENSOR ASSEMBLY


H043784E03
  1. Install the airbag sensor with the 3 bolts.

    Torque:
    17.5 N*m{ 178 kgf*cm , 13 ft.*lbf }

    CAUTION:
    1. If the airbag sensor has been dropped, or there are any cracks, dents or other defects in the case, bracket or connector, replace it with a new one.
    2. When installing the airbag sensor, be careful that the SRS wiring does not interfere with other parts and that it is not pinched between other parts.

  1. Connect the airbag sensor connectors.



2. INSTALL NO. 3 AIR DUCT REAR


3. INSTALL INSTRUMENT PANEL FINISH PANEL LOWER CENTER


B074061E03
  1. Attach the 4 claws and 2 clips to install the instrument panel finish panel.

  1. Install the clip.



4. CONNECT CABLE TO NEGATIVE BATTERY TERMINAL


5. PERFORM INITIALIZATION
  1. Perform initialization (Click here).

    NOTICE:
    Certain systems need to be initialized after disconnecting and reconnecting the cable from the negative (-) battery terminal.



6. CHECK SRS WARNING LIGHT
  1. Check the SRS warning light (Click here).