SFI SYSTEM > READINESS MONITOR DRIVE PATTERN |
| PURPOSE OF THE READINESS TESTS |
| CATALYST MONITOR (A/F SENSOR TYPE) |

Preconditions
The monitor will not run unless:
Drive Pattern
Connect Techstream or OBD II scan tool to the DLC3 to check readiness monitor status and preconditions.
Put the engine in inspection mode (Click here).
Start the engine and warm it up.
Drive the vehicle at 70 to 88 km/h (44 to 55 mph) for approximately 4 minutes (the engine must be run during monitoring).
Drive the vehicle allowing speed to fluctuate between 70 and 88 km/h (44 and 55 mph) for about 16 minutes.
Check the status of the readiness monitor on the scan tool display. If readiness monitor status did not switch to "complete", verify that the preconditions are met, turn the power switch OFF, and then repeat steps (4) and (5).
| EVAP MONITOR (KEY OFF TYPE) |
Preconditions
Monitor Conditions
Turn the power switch OFF and wait for 6 hours.
Monitor Status
Connect Techstream to the DLC3.
Turn the power switch ON (IG) and turn the tester ON.
Check the Readiness Monitor status displayed on the tester.
| OXYGEN / AIR FUEL RATIO SENSOR MONITOR (FRONT A/F SENSOR AND REAR O2S SYSTEM) |

Preconditions
The monitor will not run unless:
MIL is OFF
Drive Pattern
Connect Techstream or OBD II scan tool to the DLC3 to check monitor status and preconditions.
Put the engine in inspection mode.
Start the engine and allow it to idle for 2 minutes.
Deactivate the inspection mode and drive the vehicle at 70 to 88 km/h (44 to 55 mph) or more for 5 to 10 minutes.
Check the readiness monitor status. If the readiness monitor status did not switch to "complete", check the preconditions, turn the power switch OFF, and then repeat steps (1) to (4).
| OXYGEN / A/F SENSOR HEATER MONITOR |

Preconditions
The monitor will not run unless:
MIL is OFF.
Drive Pattern
Connect Techstream or OBD II scan tool to the DLC3 to check monitor status and preconditions.
Put the engine in inspection mode.
Start the engine and allow it to idle for 500 seconds or more.
Deactivate the inspection mode and drive the vehicle at 40 km/h (25 mph) or more for at least 2 minutes.
Check the readiness monitor status. If the readiness monitor status did not change to "complete", check the preconditions, turn the power switch OFF, and repeat steps (2) and (3).