HYBRID CONTROL SYSTEM > PRECAUTION |
| 1.PRECAUTIONS FOR INSPECTING THE HYBRID CONTROL SYSTEM |
![]() |
Before inspecting the high-voltage system, take safety precautions to prevent electrical shocks, such as wearing insulated gloves and removing the service plug grip (Click here). After removing the service plug grip, put it in your pocket to prevent other technicians from reconnecting it while you are servicing the high-voltage system.
After disconnecting the service plug grip, wait for at least 5 minutes before touching any of high-voltage connectors or terminals.
Since liquid leakage may occur, wear protective goggles when checking inside the HV battery.
Wear insulated gloves, turn the power switch OFF, and disconnect the negative terminal of the auxiliary battery before touching any of the orange-colored wires of the high-voltage system.
Turn the power switch OFF before performing a resistance check.
Turn the power switch OFF before disconnecting or reconnecting any connector.
To install the service plug grip, the lever must be flipped and locked downward. Once it is locked in place, it turns the interlock switch ON. Make sure to lock it securely because if you leave it unlocked, the system will output a DTC pertaining to the interlock switch system.

| 2.NOTICE FOR INITIALIZATION |
| System Name | See Procedure |
| Power Window Control System |
Click here
|
| 3.NOTICE FOR HYBRID SYSTEM ACTIVATION |