HYBRID BATTERY SYSTEM > DIAGNOSIS SYSTEM |
| DESCRIPTION |
![]() |
![]() |
| CHECK DLC3 |
![]() |
| Symbols (Terminal No.) | Terminal Description | Condition | Specified Condition |
| SIL (7) - SG (5) | Bus "+" line | During transmission | Pulse generation |
| CG (4) - Body ground | Chassis ground | Always | Below 1 Ω |
| SG (5) - Body ground | Signal ground | Always | Below 1 Ω |
| BAT (16) - Body ground | Battery positive | Always | 9 to 14 V |
| CANH (6) - CANL (14) | HIGH-level CAN bus line | Ignition switch OFF | 54 to 69 Ω |
| CANH (6) - Battery positive | HIGH-level CAN bus line | Ignition switch OFF | 1 MΩ or higher |
| CANH (6) - CG (4) | HIGH-level CAN bus line | Ignition switch OFF | 200 Ω or higher |
| CANL (14) - Battery positive | LOW-level CAN bus line | Ignition switch OFF | 1 MΩ or higher |
| CANL (14) - CG (4) | LOW-level CAN bus line | Ignition switch OFF | 200 Ω or higher |
| INSPECT AUXILIARY BATTERY |
Measure the voltage of the auxiliary battery.
Inspect the auxiliary battery, fuses, fusible links, wiring harness, connectors and ground.
| CHECK MIL |
![]() |
The MIL illuminates when the power switch is turned ON (IG) and the "READY" light is OFF.
If the MIL is not illuminated, troubleshoot the MIL circuit (Click here).
![]() |
When the "READY" light turns illuminated, the MIL should turn off.
If the MIL remains on, the diagnosis system has detected a malfunction or abnormality in the system.