SFI SYSTEM > MIL Circuit |

| 1.CHECK MIL CONDITION |
Perform troubleshooting in accordance with the chart below.
| Condition | Proceed to |
| MIL remains ON | A |
| MIL does not illuminate | B |
|
| ||||
| A | |
| 2.CLEAR DTC |
Connect Techstream to the DLC3.
Turn the power ON (IG).
Turn the tester ON.
Read DTCs (Click here).
Clear the DTCs (Click here).
Check that the MIL is not illuminated.
|
| ||||
| NG | |
| 3.CHECK HARNESS AND CONNECTOR (CHECK FOR SHORT IN WIRE HARNESS) |
![]() |
Disconnect the E6 ECM connector.
Turn the power switch ON (IG).
Check that the MIL is not illuminated.
Reconnect the ECM connector.
|
| ||||
| NG | ||
| ||
| 4.CHECK THAT MIL IS ILLUMINATED |
Check that the MIL is illuminated when the power switch is turned ON (IG).
|
| ||||
| NG | |
| 5.CHECK THAT ENGINE STARTS |
Turn the power switch ON (IG).
Start the engine.
| Result | Proceed To |
| Engine starts | A |
| Engine does not start* | B |
|
| ||||
| A | |
| 6.INSPECT COMBINATION METER ECU (MIL CIRCUIT) |
See the combination meter troubleshooting (Click here).
|
| ||||
| OK | ||
| ||