HYBRID BATTERY SYSTEM > DTC CHECK / CLEAR |
| CHECK DTC (HV BATTERY) |
Connect the Techstream to the DLC3.
Turn the power switch ON (IG) and the tester ON.
Enter the following menus: Powertrain / HV Battery / DTC.
Confirm the details of the DTCs (Click here).
| CHECK FREEZE FRAME DATA |
If a DTC is present, select that DTC in order to display its freeze frame data.
Read freeze frame data recorded when the DTC was set.
| CHECK DTC (SYSTEMS OTHER THAN HV BATTERY) |
Connect the Techstream to the DLC3.
Turn the power switch ON (IG) and the tester ON.
Enter the following menus: Utility / All Codes.
If DTCs output, check the relevant system.
| CLEAR DTC |
Connect the Techstream to the DLC3.
Turn the power switch ON (IG) and the tester ON.
Check that the shift position is in the P position.
Clear DTCs and freeze frame data.
Enter the following menus: Powertrain / Hybrid Control / Trouble Codes.
Clear DTCs and freeze frame data.