CAN COMMUNICATION SYSTEM > HOW TO PROCEED WITH TROUBLESHOOTING |
| 1.INSPECT BATTERY VOLTAGE |
| |||||
| 2.CHECK AND CLEAR DTCs |
| |||||
| 3.CHECK INSTALLED SYSTEMS (ECU AND SENSOR) THAT USE CAN COMMUNICATION |
Based on the vehicle equipment and specifications, confirm the systems that use CAN communication (Click here).
| |||||
| 4.CHECK DLC3 BRANCH WIRE AND CAN NO. 1 BUS CIRCUIT MAIN WIRE (CANH - CANL) |
Turn the ignition switch off.
![]() |
Measure the resistance according to the value(s) in the table below.
| Tester Connection | Condition | Specified value | Proceed to |
| D1-6 (CANH) - D1-14 (CANL) | Ignition switch off | 54 to 69 Ω | A |
| D1-6 (CANH) - D1-14 (CANL) | Ignition switch off | 70 Ω or higher | B |
| D1-6 (CANH) - D1-14 (CANL) | Ignition switch off | Below 54 Ω | C |
|
| ||||
|
| ||||
| |||||
| 5.CHECK FOR SHORT TO GND IN CAN NO. 1 BUS (CANH, CANL - CG) |
Turn the ignition switch off.
![]() |
Measure the resistance according to the value(s) in the table below.
| Tester Connection | Condition | Specified value |
| D1-6 (CANH) - D1-4 (CG) | Ignition switch off | 200 Ω or more |
| D1-14 (CANL) - D1-4 (CG) | Ignition switch off | 200 Ω or more |
|
| ||||
| |||||
| 6.CHECK FOR SHORT TO +B IN CAN NO. 1 BUS (CANH, CANL - BAT) |
Disconnect the negative battery terminal.
![]() |
Measure the resistance according to the value(s) in the table below.
| Tester Connection | Condition | Specified value |
| D1-6 (CANH) - D1-16 (BAT) | Negative battery terminal disconnected | 6 kΩ or more |
| D1-14 (CANL) - D1-16 (BAT) | Negative battery terminal disconnected | 6 kΩ or more |
|
| ||||
| |||||
| 7.CHECK FOR INSTALLED SYSTEMS (ECUS & SENSORS) THAT ADOPT CAN COMMUNICATION |
Check which of the following is adopted: dynamic radar / laser cruise control and vehicle stability control.
| |||||
| 8.CHECK TECHSTREAM |
Using Techstream, select "CAN Bus Check" from the "System Select".
Observe the screen for approximately 1 minute to check the ECUs and sensors displayed on the screen.
| Result | Proceed to |
| All ECUs and sensors connected to the CAN communication system are displayed on the screen. (CAN bus circuit is currently normal) | A |
| One of the ECUs and sensors connected to the CAN communication system is not displayed on the screen. (Open in ECU or sensor branch wires, or communication interrupted) | B |
|
| ||||
| |||||
| 9.DTC COMBINATION TABLE |
Confirm trouble according to the combination of output DTCs regarding the CAN communication system (Click here).
| |||||
| 10.CIRCUIT INSPECTION |
| |||||
| 11.IDENTIFICATION OF PROBLEM |
| |||||
| 12.REPAIR OR REPLACE |
| |||||
| 13.CONFIRMATION TEST |
|
| ||||
|---|---|---|---|---|---|