Home › ENGINE › 1NZ-FXE ENGINE CONTROL SYSTEM › SFI SYSTEM

DTC    U0293    Lost Communication with HV ECU

for Preparation Click here


DESCRIPTION

The Controller Area Network (CAN) is a serial data communication system for real-time application. It is a multiplex communication system designed for on-vehicle use that provides a superior communication speed of 500 kbps and a capability to detect malfunction. Through the combination of the CANH and CANL bus lines, the CAN is able to maintain communication based on differential voltage.

HINT:
  1. Malfunction in the CAN bus (communication line) can be checked through the DLC3 connector, except in case of an open circuit in the DLC3 sub bus line.
  2. DTCs pertaining to CAN communication can be accessed through the use of Techstream.
  3. Malfunctions in the DLC3 sub bus line cannot be detected through CAN communication, even though the DLC3 connector is connected to CAN communication.


DTC No.
DTC Detection Condition
Trouble Area
U0293
When communication with HV ECU is interrupted
  1. Wire harness
  2. HV ECU
  3. ECM

MONITOR DESCRIPTION

The ECM and the HV control ECU are connected through a set of communication lines on the CAN, in order to maintain mutual communication. The ECM uses the communication lines to transmit the engine speed or other pieces of information to the HV control ECU. The HV control ECU transmits signals such as an engine torque request signal to the ECM.
A few seconds after the power switch is turned ON (IG), the ECM starts checking for any malfunction in the communication with the HV ECU. If the ECM detects a malfunction in the communication, the ECM sets a DTC and illuminates the MIL.

MONITOR STRATEGY


Related DTCs
U0293: Lost communication with HV ECU
Required sensors/components
ECM
Frequency of operation
Continuous
Duration
0.68 seconds
MIL operation
Immediately
Sequence of operation
None

TYPICAL ENABLING CONDITIONS


The monitor will run whenever the following DTCs are not present
None
Power switch
ON

TYPICAL MALFUNCTION THRESHOLDS


Communication signal
No signal from HV ECU

WIRING DIAGRAM

Refer to CAN Communication System (Click here).

INSPECTION PROCEDURE

Refer to CAN Communication System (Click here).

HINT:
Read freeze frame data using Techstream. The ECM records vehicle and driving condition information as freeze frame data the moment a DTC is stored. When troubleshooting, freeze frame data can be helpful in determining whether the vehicle was running or stopped, whether the engine was warmed up or not, whether the air/fuel ratio was lean or rich, as well as other data recorded at the time of a malfunction.