Home › SECURITIES › ENGINE IMMOBILISER › ENGINE IMMOBILISER SYSTEM (w/o Smart Key System)

ENGINE IMMOBILISER SYSTEM (w/o Smart Key System) > HOW TO PROCEED WITH TROUBLESHOOTING

for Preparation Click here


HINT:
  1. Use these procedures to troubleshoot the engine immobiliser system.
  2. *: Use the Techstream.



1.VEHICLE BROUGHT TO WORKSHOP

    NEXT


    2.INSPECT BATTERY VOLTAGE

      Standard voltage:
      11 to 14 V

      If the voltage is below 11 V, recharge or replace the battery before proceeding

    NEXT


    3.START HYBRID CONTROL SYSTEM

      Result: 
      Result
      Proceed to
      Power switch cannot be turned ON (ACC) or when hybrid control system can be started
      A
      Power switch can be turned ON (ACC) and hybrid control system cannot be started
      B


    B.
    Go to HYBRID CONTROL SYSTEM
    A


    4.CHECK FOR DTC*
    1. Check for DTCs and note any codes that are output (Click here).

    2. Delete the DTC.

    3. Recheck for DTCs. Try to prompt the DTC by simulating the original activity that the DTC suggests.
      Result: 
      Result
      Proceed to
      DTC reoccurs
      A
      DTC does not reoccur
      B



    B.
    Go to step 7
    A


    5.PROBLEM SYMPTOMS TABLE
      Result: 
      Result
      Proceed to
      Fault is not listed in problem symptoms table
      A
      Fault is listed in problem symptoms table
      B


    B.
    Go to step 7
    A


    6.OVERALL ANALYSIS AND TROUBLESHOOTING*
    1. DATA LIST/ACTIVE TEST (Click here)

    2. Terminals of ECU (Click here)


    NEXT


    7.ADJUST, REPAIR OR REPLACE

      NEXT


      8.CONFIRMATION TEST

        NEXT

        END