Home › SECURITIES › ENGINE IMMOBILISER › ENGINE IMMOBILISER SYSTEM (w/ Smart Key System)

DTC    B2775    Interior Verification Abnormal (To Theft Deterrent ECU)

for Preparation Click here


DESCRIPTION

This DTC is output when: 1) there is no response from the certification ECU, 2) the ECU communication ID was unable to be registered properly, 3) a communication error occurs between the transponder key ECU and certification ECU.

DTC No.
DTC Detection Condition
Trouble Area
B2775
When any of following conditions are met:
  1. There is no response from certification ECU
  2. ECU communication ID is unable to be registered properly
  3. Communication error occurs between transponder key ECU and certification ECU
  1. Transponder key ECU
  2. Certification ECU
  3. Smart key system (for door lock)

INSPECTION PROCEDURE

1.CHECK FOR DTC
  1. Delete the DTC (Click here).

  1. Check for DTCs when turning the power switch ON (IG) without inserting the key into the key slot.
    Result: 
    Result
    Proceed to
    DTC reoccurs
    A
    DTC does not reoccur
    B



B
NORMAL
A


2.CHECK CERTIFICATION ECU (VERIFICATION)
  1. Check that the smart indicator on the meter is ON.
    Result: 
    Result
    Proceed to
    Smart indicator is ON
    A
    Smart indicator is OFF
    B



B
GO TO SMART KEY SYSTEM (for Door lock)
A


3.CHECK TRANSPONDER KEY ECU
  1. Insert the key into the key slot.

  1. Check that the power switch can be turned ON (IG).

    OK:
    Power switch can be turned ON (IG).



OK
Go to step 5
NG


4.CHECK FOR DTC (IMMOBILISER SYSTEM DTC)
  1. Check for DTCs and note any codes that are output (Click here).

  1. Delete the DTC.

  1. Recheck for DTCs. Try to prompt the DTC by simulating the original activity that the DTC suggests.
    Result: 
    Result
    Proceed to
    DTC does not reoccur
    A
    DTC reoccurs
    B



NG
GO TO DTC CHART
OK


5.REREGISTER ECU COMMUNICATION ID CODE
  1. Reregister the ECU communication ID code with a transponder key ECU and certification ECU (Click here).

  1. Check that the power switch can be turned ON (IG) even if the key is not inserted into the key slot.

    OK:
    Power switch can be turned ON (IG) without key in key slot



OK
NORMAL
NG


6.CHECK TRANSPONDER KEY ECU (OPERATION)
  1. Temporarily replace the transponder key ECU with a new or normally functioning one.

  1. Check that the power switch can be turned ON (ACC or IG) and the hybrid control system can be started.

    Result: 
    Result
    Proceed to
    Power switch can be turned ON (ACC and IG) and hybrid control system can be started with/without inserting key into key slot
    A
    Power switch cannot be turned ON (ACC and IG) and hybrid control system cannot be started without inserting key into key slot
    B
    Power switch cannot be turned (ACC and IG) and hybrid control system cannot be started with inserting key into key slot
    C



B
REPLACE CERTIFICATION ECU

C
GO TO SMART KEY SYSTEM
A

END (TRANSPONDER KEY ECU IS DEFECTIVE)