ENGINE IMMOBILISER SYSTEM (w/ Smart Key System) > REGISTRATION |
| 1. DESCRIPTION OF CODE REGISTRATION |
| 2. PART REPLACEMENT AND KEY REGISTRATION PROCEDURES |
The following table shows ECU replacement and key registration procedures in case the malfunctioning ECU has been determined after troubleshooting the engine immobiliser system.
| Part to be replaced | Procedure | Refer to |
| Transponder key ECU | 1. Replace transponder key ECU | - |
| 2. Reregister all keys | "KEY REGISTRATION IN AUTOMATIC REGISTRATION (NEW REGISTRATION)" | |
| 3. Using SST (09843-018040), connect terminals TC and CG of DLC3 | "ECU CODE REGISTRATION (TRANSPONDER KEY ECU - HYBRID VEHICLE CONTROL ECU)" | |
| 4. Turn power switch ON (IG) and leave it as is for 30 minutes | ||
| 5. Register ECU communication ID to be used between certification ECU and transponder key ECU | "ECU CODE REGISTRATION (TRANSPONDER KEY ECU - CERTIFICATION ECU)" | |
| Certification ECU | 1. Replace certification ECU | - |
| 2. Register ECU communication ID to be used between certification ECU and transponder key ECU | "ECU CODE REGISTRATION (TRANSPONDER KEY ECU - CERTIFICATION ECU)" | |
| Hybrid vehicle control ECU | 1. Replace ECM | Refer to replacement (Click here) |
| 2. Using SST (09843-018040), connect terminals TC and CG of DLC3 | "ECU CODE REREGISTRATION (TRANSPONDER KEY ECU - HYBRID VEHICLE CONTROL ECU)" | |
| 3. Turn power switch ON (IG) and leave it as is for 30 minutes | ||
| Key | 1. Using remaining key, erase key code of lost key | "ERASURE OF KEY CODE" |
| 2. Register additional keys as necessary | "REGISTRATION OF ADDITIONAL KEY (ADDITIONAL REGISTRATION)" |
| 3. KEY REGISTRATION IN AUTOMATIC REGISTRATION (NEW REGISTRATION) |
When a key is inserted into the key slot, the key code (immobiliser code) registration is automatic. In this mode, a maximum of 2 key codes can be registered.

End automatic key code registration mode.
Automatic key code registration mode can be forced to end when at least 1 key code (immobiliser code) for the key has been registered.
Turn the power switch from ON (IG) and OFF 5 times within 10 seconds using the already registered key.

| 4. REGISTRATION OF ADDITIONAL KEY (ADDITIONAL REGISTRATION) |
Register an additional key using the Techstream.

| 5. ERASURE OF KEY CODE |
Erase the key codes using the Techstream.

| 6. ECU COMMUNICATION ID REGISTRATION (TRANSPONDER KEY ECU - HYBRID VEHICLE CONTROL ECU) |
Register the ECU communication ID.
Using SST, connect terminals TC and CG of the DLC3.

Turn the power switch ON (IG) (do not start the hybrid control system) and leave it as is for 30 minutes.
Turn the power switch OFF and disconnect terminals TC and CG.
Check that the hybrid control system starts.
| 7. ECU COMMUNICATION ID REGISTRATION (TRANSPONDER KEY ECU - CERTIFICATION ECU) |

| 8. ECU COMMUNICATION ID REREGISTRATION (TRANSPONDER KEY ECU - HYBRID VEHICLE CONTROL ECU) |
Insert the already registered key in the key slot and turn the power switch ON (READY) with the brake pedal depressed.
Check that the hybrid control system stays on for more than 3 seconds.