Home › BODY ELECTRICAL › DOOR LOCK › POWER DOOR LOCK CONTROL SYSTEM

POWER DOOR LOCK CONTROL SYSTEM > HOW TO PROCEED WITH TROUBLESHOOTING

for Preparation Click here


HINT:
  1. Use this procedure to troubleshoot the power door lock control system.
  2. *: Using the Techstream.



1.VEHICLE BROUGHT TO WORKSHOP

    NEXT


    2.CUSTOMER PROBLEM ANALYSIS CHECK AND SYMPTOM CHECK

      NEXT


      3.INSPECT BATTERY VOLTAGE

        Standard voltage:
        11 to 14 V

        If the voltage is below 11 V, recharge or replace the battery before proceeding.

      NEXT


      4.INSPECT COMMUNICATION FUNCTION OF LARGE-SCALE MULTIPLEX COMMUNICATION SYSTEM (BEAN)*
      1. Use the Techstream to check if the Multiplex Communication System (MPX) is functioning normally.
        Result 
        Result
        Proceed to
        MPX DTC is not output
        A
        MPX DTC is output
        B



      B.
      Go to MULTIPLEX COMMUNICATION SYSTEM
      A


      5.CHECK FOR DTC*
        Result 
        Result
        Proceed to
        DTC is not output
        A
        DTC is output
        B


      B.
      Go to step 7
      A


      6.PROBLEM SYMPTOMS TABLE

        Result 
        Result
        Proceed to
        Fault is not listed in problem symptoms table
        A
        Fault is listed in problem symptoms table
        B


      B.
      Go to step 8
      A


      7.OVERALL ANALYSIS AND TROUBLESHOOTING
      1. Operation check (Click here)

      2. Terminals of ECU (Click here)

      3. DATA LIST/ACTIVE TEST (Click here)


      NEXT


      8.REPAIR OR REPLACE

        NEXT


        9.CONFIRMATION TEST

          NEXT

          END