Home › HYBRID SYSTEM › P112 HYBRID BATTERY CONTROL › JUNCTION BLOCK

JUNCTION BLOCK > REMOVAL

for Preparation Click here


CAUTION:
  1. When working on the high voltage systems, always wear insulating gloves.
  2. Keep the removed service plug in your pocket to prevent other technicians from reconnecting it while you are servicing the vehicle.
  3. After removing the service plug grip, do not touch the high voltage connectors and terminals for 5 minutes.

NOTICE:
After removing the service plug grip, do not operate the power switch as it may damage the hybrid vehicle control ECU.



1. PRECAUTION

CAUTION:
The hybrid system uses high voltage circuits, so improper handling could cause an electric shock or leakage. During service (including installation/removal, inspection and replacement of parts), be sure to follow the procedures (Click here).



2. REMOVE REAR NO. 2 FLOOR BOARD


    A088353E01
  1. Unlock the 2 washer tank cover knobs, and then remove the rear floor board.



3. REMOVE REAR DECK FLOOR BOX


    A088354E01
  1. Remove the rear deck floor box from the vehicle.



4. REMOVE REAR NO. 3 FLOOR BOARD


    A088355E02
  1. Detach the 4 claws, and then remove the floor board.



5. DISCONNECT CABLE FROM NEGATIVE BATTERY TERMINAL

CAUTION:
Wait at least 90 seconds after disconnecting the cable from the negative (-) battery terminal to prevent airbag and seat belt pretensioner activation.



6. REMOVE SERVICE PLUG GRIP


A083545E03

CAUTION:
Wear insulating gloves.

  1. Slide up the lever of the service plug grip. Remove the service plug grip while turning the lever to the left.

  1. Insulate the service plug with insulating tape.



7. REMOVE HV BATTERY ASSEMBLY
  1. Remove the HV battery from the vehicle (Click here).



8. REMOVE BATTERY COVER


    A083610E01
  1. Remove the protector shown in the illustration.



  1. Remove the 6 bolts, 2 nuts, clip, battery cover and battery carrier catch bracket.


    A083611E01



9. REMOVE NO. 2 WIRE HARNESS PROTECTOR COVER


A083565E02

CAUTION:
Wear insulating gloves.



10. REMOVE NO. 4 WIRE HARNESS PROTECTOR COVER

CAUTION:
Wear insulating gloves.



11. REMOVE JUNCTION BLOCK


A083549E01

CAUTION:
Wear insulating gloves.

  1. Remove the 26 nuts and junction block.