Home › CRUISE CONTROL SYSTEM › CRUISE CONTROL › CRUISE CONTROL SYSTEM

DTC    P0607    Control Module Performance

for Preparation Click here


DESCRIPTION

DTC P0607 will be stored if an internal malfunction of the hybrid vehicle control ECU or a stop light switch malfunction is detected.

DTC No.
DTC Detection Condition
Trouble Area
P0607
Hybrid vehicle control ECU has a supervisory CPU and a control CPU. Trouble code is output when input STP signals to each CPU are different for 0.15 seconds or more.
  1. Stop light switch
  2. Hybrid vehicle control ECU

HINT:
If DTC P0607 is detected while the cruise control is in operation, the system clears the stored vehicle speed in the hybrid vehicle control ECU and cancels the cruise control operation. At the same time, the CRUISE main indicator light blinks to inform the driver of the malfunction.
When this trouble code is detected, fail-safe remains on until the power switch is turned OFF.


INSPECTION PROCEDURE

1.INSPECT STOP LIGHT SWITCH ASSEMBLY


    I004062E05
  1. Remove the stop light switch.

  1. Measure the resistance of the switch.

    Standard resistance:
    Tester Connection
    Switch Condition
    Specified Condition
    1 - 2
    Not pushed
    Below 1 Ω
    Pushed
    10 kΩ or higher



NG
REPLACE STOP LIGHT SWITCH ASSEMBLY
OK


2.CHECK DTC
  1. Clear the DTC (Click here).

  1. Check the DTC (Click here).

    OK:
    DTC is not output.



NG
REPLACE HYBRID VEHICLE CONTROL ECU (Click here)
OK

END