CRUISE CONTROL SYSTEM > DIAGNOSIS SYSTEM |
| DESCRIPTION |
| CHECK DLC3 |
![]() |
The hybrid vehicle control ECU of the vehicle uses ISO 15765-4 for communication protocol. The terminal arrangement of the DLC3 complies with SAE J1962 and matches the ISO 15765-4 format.
| Symbols (Terminal No.) | Terminal Description | Condition | Specified condition |
| SIL (7) - SG (5) | Bus "+" line | During transmission | Pulse generation |
| CG (4) - Body ground | Chassis ground | Always | Below 1 Ω |
| SG (5) - Body ground | Signal ground | Always | Below 1 Ω |
| BAT (16) - Body ground | Battery positive | Always | 10 to 14 V |
| CANH (6) - CANL (14) | CAN bus line | Power switch is OFF* | 54 to 69 Ω |
| CANH (6) - CG (4) | HIGH-level CAN bus line | Power switch is OFF* | 200 Ω or higher |
| CANL (14) - CG (4) | LOW-level CAN bus line | Power switch is OFF* | 200 Ω or higher |
| CANH (6) - BAT (16) | HIGH-level CAN bus line | Power switch is OFF* | 6 kΩ or higher |
| CANL (14) - BAT (16) | LOW-level CAN bus line | Power switch is OFF* | 6 kΩ or higher |
Connect the cable of the Techstream to the DLC3, turn the power switch on (IG) and attempt to use the Techstream. If the display indicates that a communication error has occurred, there is a problem with either the vehicle or the Techstream.
| CHECK INDICATOR |
![]() |
Turn the power switch on (IG).
Check that the CRUISE main indicator light comes on when the cruise control main switch ON-OFF button is pushed on, and that the indicator light goes off when the ON-OFF button is pushed off.