Home › COMMUNICATION SYSTEM › MULTIPLEX COMMUNICATION › MULTIPLEX COMMUNICATION SYSTEM

MULTIPLEX COMMUNICATION SYSTEM > HOW TO PROCEED WITH TROUBLESHOOTING

for Preparation Click here


HINT:
  1. Use this procedure to troubleshoot the multiplex communication system.
  2. *: Use Techstream.



1.VEHICLE BROUGHT TO WORKSHOP

    NEXT


    2.CHECK BATTERY VOLTAGE

      Standard voltage:
      11 V or higher

      If the voltage is below 11 V, recharge or replace the battery before proceeding.

    NEXT


    3.CHECK DTC OF CAN COMMUNICATION SYSTEM
    1. Using Techstream, check if the CAN is functioning normally.
      Result: 
      Result
      Proceed to
      CAN DTC is not output
      A
      CAN DTC is output
      B



    B.
    Go to CAN COMMUNICATION SYSTEM
    A


    4.CHECK FOR DTC*
    1. Check for DTCs and note any codes that are output (Click here).

    2. Delete the DTC.

    3. Recheck for DTCs. Try to prompt the DTC by simulating the original activity that the DTC suggests.
      Result: 
      Result
      Proceed to
      DTC does not reoccur
      A
      DTC reoccurs
      B



    B.
    Go to step 6
    A


    5.OVERALL ANALYSIS AND TROUBLESHOOTING
    1. Terminals of ECU (Click here).


    NEXT


    6.ADJUST, REPAIR OR REPLACE

      NEXT


      7.CONFIRMATION TEST

        NEXT

        END