FUEL SYSTEM > ON-VEHICLE INSPECTION |
| 1. CHECK FUEL PRESSURE |
Discharge fuel system pressure .
Using a voltmeter, measure the battery voltage.
Disconnect the cable from the negative (-) battery terminal.
Disconnect the fuel tube .
![]() |
Install SST (pressure gauge) using other SST as shown in the illustration.
Wipe up any gasoline.
Connect the cable to the negative (-) battery terminal.
Connect the Techstream to the DLC3.
Measure the fuel pressure.
Disconnect the Techstream from the DLC3.
Set the vehicle to inspection mode (Click here).
Start the engine.
Measure the fuel pressure at idle.
Stop the engine.
After stopping the engine, check that the fuel pressure does not change for 5 minutes.
After checking the fuel pressure, disconnect the cable from the negative (-) battery terminal and carefully remove SST to prevent gasoline from spilling out.
Connect the fuel tube .
| 2. CHECK FUEL PUMP |
Connect the Techstream to the DLC3.
Turn the power switch on (IG).
Turn the Techstream on.
Select the following menu items: Power train / Engine and ECT / Active Test / Control the Fuel Pump Speed.
Check the fuel pump operation while operating it with the Techstream.
If the fuel pump does not operate, replace the fuel tank.
| 3. INSPECT FOR FUEL LEAK |
Check that there are no leaks in the fuel system while fuel pressure is applied.