Home › ENGINE › 1NZ-FXE FUEL › FUEL INJECTOR

FUEL INJECTOR > INSPECTION

for Preparation Click here



1. INSPECT FUEL INJECTOR ASSEMBLY


    A087468E02
  1. Measure the resistance between the terminals.

    Standard resistance:
    13.45 to 14.15 Ω at 21°C (70°F)

    If the resistance is not as specified, replace the fuel injector assembly.



  1. Inspect the injection volume.

    CAUTION:
    Perform the test in a well-ventilated area away from flames.




      A088228E08
    1. Connect SST (fuel tube connector) to SST (hose) then connect them to the fuel tube (the vehicle side).

      SST
      09268-31012   (09268-41500, 90467-13001, 95336-08070)



    2. A088230E02
    3. Install the O-ring to the fuel injector.

      SST
      09268-31012   (09268-41110, 09268-41300, 90467-13001)

    4. Connect SST (adapter and hose) to the injector, and hold the injector and union with SST (clamp).

    5. Install SST and the vinyl tube to the fuel injector.



    6. A088346E03
    7. Set the fuel injector to a graduated cylinder.

    8. Operate the fuel pump (Click here).

    9. Install SST to the fuel injector.

      SST
      09842-30080  

    10. Connect SST to the battery, then measure the injection volume for 15 seconds. Perform the inspection 2 or 3 times, then calculate the average.

      Standard injection volume:
      Injection Volume
      Difference between each fuel injector
      36 to 46 cm3 (2.1 to 2.8 cu in.)
      10 cm3 (0.6 cu in.) or less

      NOTICE:
      Always turn the voltage on and off on the battery side, not the fuel injector side.

      If the injection volume is not as specified, replace the fuel injector assembly.



  1. Inspect the fuel leakage.



      A088303E01
    1. In the condition that the injection volume was inspected, remove SST from the battery. Inspect the fuel leakage from the fuel injector.

      Standard fuel drop:
      1 drop or less per 12 minutes

      If the fuel leakage is not as specified, replace the fuel injector assembly.