Home › HEATER & AIR CONDITIONING SYSTEM › AIR CONDITIONING › CONDENSER

CONDENSER > REMOVAL

for Preparation Click here




1. DISCHARGE REFRIGERANT FROM REFRIGERATION SYSTEM
  1. Turn the A/C switch on.

  1. Operate the A/C with the setting temperature at 25 °C (77°F) and the blower level at LO for 10 minutes to circulate the refrigerant, and collect compressor oil remaining in each component into the cooler compressor as much as possible.

  1. Stop the engine.

  1. Recover the refrigerant from the A/C system using a refrigerant recovery unit.



2. REMOVE FRONT FENDER LINER LH


    B130315
  1. Using a clip remover, remove the clip.

  1. Partially remove the fender liner.

    HINT:
    It is not necessary to fully remove the fender liner. Partially remove it so that the bumper cover can be removed in a later step.



3. REMOVE FRONT FENDER LINER RH

HINT:
Use the same procedure described for the LH side.



4. REMOVE FRONT BUMPER COVER
  1. Remove the front bumper cover (Click here).



5. REMOVE NO. 1 INVERTER BRACKET


6. DISCONNECT DISCHARGE HOSE SUB-ASSEMBLY


    I038554E01
  1. Remove the bolt and disconnect the discharge hose from the condenser (with receiver).

  1. Remove the O-ring from the discharge hose.

    NOTICE:
    Seal the openings of the disconnected parts of the discharge hose and the condenser using vinyl tape to prevent moisture and foreign matter from entering them.



7. DISCONNECT COOLER REFRIGERANT LIQUID PIPE E (TO COOLER UNIT)


    I038555E01
  1. Remove the bolt and disconnect the cooler unit refrigerant liquid pipe E from the condenser (with receiver).

  1. Remove the O-ring from the cooler refrigerant liquid pipe E.

    NOTICE:
    Seal the openings of the disconnected parts of the cooler unit refrigerant liquid pipe E and the condenser using vinyl tape to prevent moisture and foreign matter from entering them.



8. REMOVE RADIATOR SUPPORT SUB-ASSEMBLY UPPER RH


    I038556E01
  1. Remove the 4 bolts and radiator support upper.



9. REMOVE RADIATOR SUPPORT SUB-ASSEMBLY UPPER LH


    I038982E01
  1. Remove the 4 bolts and radiator support upper.



10. REMOVE CONDENSER ASSEMBLY WITH RECEIVER


    I038557E01
  1. Remove the 2 angles.



    I038558E01
  1. Remove the 2 bolts and condenser (with receiver).