Home › BRAKE › BRAKE CONTROL › ELECTRONICALLY CONTROLLED BRAKE SYSTEM

ELECTRONICALLY CONTROLLED BRAKE SYSTEM > ABS Warning Light Remains ON

for Preparation Click here


DESCRIPTION

The ABS warning light illuminates to inform the driver that there is a problem in the ABS.
When DTC output is normal and the ABS warning light remains on, perform troubleshooting as indicated below.

WIRING DIAGRAM


C153501E01


C153494E01


INSPECTION PROCEDURE

NOTICE:
When replacing the skid control ECU, perform initialization of linear solenoid valve and calibration (Click here).

1.CHECK SKID CONTROL ECU (BS1, BS2 VOLTAGE)


    F047485E78
  1. Measure the voltage of the connectors.

    HINT:
    Measure the voltage from behind the connector with the connector connected to the skid control ECU.

    Standard voltage:
    Tester Connection
    Specified Condition
    S7-3 (BS1) - Body ground
    10 to 14 V
    S10-7 (BS2) - Body ground
    10 to 14 V



NG
REPAIR OR REPLACE HARNESS AND CONNECTOR
OK


2.PERFORM ACTIVE TEST BY TECHSTREAM (ABS WARNING LIGHT)
  1. Select the Active Test, generate a control command, and then check that the ABS warning light operates.

    ABS / VSC / TRAC: 
    Tester Display
    Test Part
    Control Range
    Diagnostic Note
    ABS Warning Light
    ABS warning light
    Warning light ON / OFF
    Observe combination meter

    OK:
    The ABS warning light turns on or off.



NG
REPAIR OR REPLACE COMBINATION METER ASSEMBLY
OK

REPLACE SKID CONTROL ECU