Home › BRAKE › BRAKE CONTROL › ELECTRONICALLY CONTROLLED BRAKE SYSTEM

ELECTRONICALLY CONTROLLED BRAKE SYSTEM > VSC Warning Light Remains ON

for Preparation Click here


DESCRIPTION

The VSC warning light illuminates to inform the driver that there is a problem in the Enhanced VSC. When DTC output is normal and the VSC warning light remains on, perform troubleshooting as indicated below.

WIRING DIAGRAM


C153502E01


C153494E01


INSPECTION PROCEDURE

NOTICE:
When replacing the skid control ECU, perform initialization of linear solenoid valve and calibration (Click here).

1.CHECK SKID CONTROL ECU CONNECTOR
  1. Check the skid control ECU connector's connecting condition.

    OK:
    The connector should be securely connected.



NG
CONNECT CONNECTOR TO ECU CORRECTLY
OK


2.PERFORM ACTIVE TEST BY TECHSTREAM (VSC WARNING LIGHT)
  1. Select the Active Test, generate a control command, and then check that the VSC warning light operates.

    ABS / VSC / TRAC: 
    Tester Display
    Test Part
    Control Range
    Diagnostic Note
    VSC Warning Light
    VSC warning light
    Warning light ON / OFF
    Observe combination meter

    OK:
    The VSC warning light turns on or off.



NG
REPAIR OR REPLACE COMBINATION METER ASSEMBLY
OK

REPLACE SKID CONTROL ECU