Home › BRAKE › BRAKE CONTROL › ELECTRONICALLY CONTROLLED BRAKE SYSTEM

ELECTRONICALLY CONTROLLED BRAKE SYSTEM > Skid Control Buzzer Circuit

for Preparation Click here


DESCRIPTION

The skid control buzzer sounds and VSC warning light comes ON during Enhanced VSC operation.

WIRING DIAGRAM


C126268E01


INSPECTION PROCEDURE

NOTICE:
When replacing the skid control ECU, perform initialization of linear solenoid valve and calibration (Click here).

1.PERFORM ACTIVE TEST BY TECHSTREAM (SKID CONTROL BUZZER)
  1. Select the Active Test, generate a control command, and then check that the skid control buzzer operates.

    ABS / VSC / TRAC: 
    Tester Display
    Test Part
    Control Range
    Diagnostic Note
    VSC H/B Warning Buzzer
    Skid control buzzer
    Buzzer ON / OFF
    Buzzer can be heard

    OK:
    The skid control buzzer can be heard.



OK
REPLACE SKID CONTROL ECU
NG


2.INSPECT SKID CONTROL BUZZER ASSEMBLY


    F002192E11
  1. Disconnect the skid control buzzer connector.

  1. Apply a battery negative voltage to terminal 1 and positive voltage to terminal 2 of the skid control buzzer connector, and check that the buzzer sounds.

    OK:
    The skid control buzzer sound should be heard.



NG
REPLACE SKID CONTROL BUZZER ASSEMBLY
OK


3.CHECK WIRE HARNESS (SKID CONTROL ECU - SKID CONTROL BUZZER)


    C126279E01
  1. Disconnect the S8 ECU connector.

  1. Disconnect the S6 buzzer connectors.

  1. Measure the resistance of the wire harness side connectors.

    Standard resistance:
    Tester Connection
    Specified Condition
    S8-33 (VBZ) - S6-2 (VBZ)
    Below 1 Ω
    S8-12 (BZ) - S6-1 (BZ)
    Below 1 Ω
    S8-33 (VBZ) - Body ground
    10 kΩ or higher
    S8-12 (BZ) - Body ground
    10 kΩ or higher



NG
REPAIR OR REPLACE HARNESS AND CONNECTOR
OK


4.CHECK WIRE HARNESS (SKID CONTROL ECU - BODY GROUND)


    F047485E79
  1. Measure the resistance of the connectors.

    Standard resistance:
    Tester Connection
    Specified Condition
    S7-1 (GND) - Body ground
    Below 1 Ω
    S8-2 (GND2) - Body ground
    Below 1 Ω
    S8-1 (GND3) - Body ground
    Below 1 Ω
    S9-2 (GND4) - Body ground
    Below 1 Ω
    S9-1 (GND5) - Body ground
    Below 1 Ω
    S10-4 (GND6) - Body ground
    Below 1 Ω



NG
REPAIR OR REPLACE HARNESS AND CONNECTOR
OK

REPLACE SKID CONTROL ECU ASSEMBLY