Home › BRAKE › BRAKE CONTROL › ELECTRONICALLY CONTROLLED BRAKE SYSTEM

DTC    C1256/57    Accumulator Low Pressure

for Preparation Click here


DESCRIPTION

The accumulator pressure sensor is built into the actuator and detects the accumulator pressure.
The skid control ECU turns on the brake control warning light and sounds the skid control buzzer if it senses a decrease in the accumulator pressure.

DTC No.
INF Code
DTC Detection Condition
Trouble Area
C1256/57
141
When either condition below is met:
  1. Braking operation is input when accumulator pressure is less than 12.45 MPa and vehicle speed is input (detected value changes if accumulator pressure is low after system start).
  2. Accumulator pressure is less than 14.62 MPa for 120 sec. (changes according to power source voltage) after system start (stores the DTC after the conditions are met, and drives buzzer).
Brake actuator assembly (accumulator pressure, accumulator pressure sensor, pump motor)
C1256/57
143
When one of following conditions is met:
  1. Any of the wheel cylinder pressure sensor value is lower than the target value for at least 0.5 sec. when accumulator pressure is less than 14.62 MPa and vehicle speed is input.
  2. Accumulator pressure changes little when accumulator pressure is less than 14.62 MPa for at least 1 sec. without braking (pump motor is operating).
  3. Accumulator pressure is less than 14.62 MPa for at least 0.5 sec. when motor relay is malfunctioning.
Brake actuator assembly (accumulator pressure, accumulator pressure sensor, pump motor)

INSPECTION PROCEDURE

NOTICE:
When replacing the skid control ECU, perform initialization of linear solenoid valve and calibration (Click here).

HINT:
DTCs may be output if the accumulator pressure drops due to frequent braking (this is not a malfunction).

1.INSPECT BRAKE ACTUATOR ASSEMBLY


    F047491E03
  1. Disconnect the brake actuator connector.

  1. Measure the resistance of the actuator.

    Standard resistance:
    Tester Connection
    Specified Condition
    A2-1 (BM2) - A2-31 (GND1)
    Below 10 Ω
    A2-2 (BM1) - A2-31 (GND1)
    Below 10 Ω
    A2-1 (BM2) - A2-2 (BM1)
    Below 1 Ω
    A2-31 (GND1) - A2-32 (GND2)
    Below 1 Ω
    A2-1 (BM2) - A2-33 (MTT)
    Approx. 10 Ω
    A2-2 (BM1) - A2-33 (MTT)
    Approx. 10 Ω



NG
REPLACE BRAKE ACTUATOR ASSEMBLY
OK


2.READ VALUE OF TECHSTREAM (ACCUMULATOR PRESSURE SENSOR)
  1. Check the Data List for proper functioning of the accumulator pressure sensor.

  1. Depress the brake pedal 4 or 5 times to operate the pump motor, and check the output value on Techstream with the motor stopped (not braking).

    ABS / VSC / TRAC: 
    Tester Display
    Measurement Item/Range
    Normal condition
    Diagnostic Note
    Accumulator Sensor 1
    Accumulator pressure sensor 1 / Min.: 0 V, Max.: 5 V
    Specified value: 3.2 to 4.0 V
    -

    OK:
    Accumulator pressure sensor's output voltage does not drop.



NG
REPLACE BRAKE ACTUATOR ASSEMBLY
OK

REPLACE SKID CONTROL ECU