Home › BRAKE › BRAKE CONTROL › ELECTRONICALLY CONTROLLED BRAKE SYSTEM

ELECTRONICALLY CONTROLLED BRAKE SYSTEM > TS and CG Terminal Circuit

for Preparation Click here


DESCRIPTION

In the sensor check mode, a malfunction of the speed sensor that cannot be detected when the vehicle is stopped is detected while driving.
Transition to the sensor check mode can be performed by connecting terminals TS and CG of the DLC3 and turning the power switch from OFF to ON (READY).

WIRING DIAGRAM


C126270E01


INSPECTION PROCEDURE

NOTICE:
When replacing the skid control ECU, perform initialization of linear solenoid valve and calibration (Click here).

1.CHECK DLC3 (TS VOLTAGE)


    C108847E38
  1. Turn the power switch ON (READY).

  1. Measure the voltage of the DLC3.

    Standard voltage:
    Tester Connection
    Specified Condition
    D1-12 (TS) - D1-4 (CG)
    10 to 14 V



NG
Go to step 3
OK


2.CHECK WIRE HARNESS (SKID CONTROL ECU - DLC3)


    C133169E01
  1. Disconnect the S8 ECU connector.

  1. Measure the resistance of the wire harness side connectors.

    Standard resistance:
    Tester Connection
    Specified Condition
    S8-32 (TS) - D1-12 (TS)
    Below 1 Ω
    S8-32 (TS) - Body ground
    10 kΩ or higher



NG
REPAIR OR REPLACE HARNESS AND CONNECTOR
OK

REPLACE SKID CONTROL ECU 

3.CHECK WIRE HARNESS (DLC3 - BODY GROUND)


    H100769E69
  1. Measure the resistance of the DLC3 connector.

    Standard resistance:
    Tester Connection
    Specified Condition
    D1-4 (CG) - Body ground
    Below 1 Ω



NG
REPAIR OR REPLACE HARNESS AND CONNECTOR
OK


4.CHECK WIRE HARNESS (SKID CONTROL ECU - DLC3)


    C133169E01
  1. Disconnect the S8 ECU connector.

  1. Measure the resistance of the wire harness side connector.

    Standard resistance:
    Tester Connection
    Specified Condition
    S8-32 (TS) - D1-12 (TS)
    Below 1 Ω
    S8-32 (TS) - Body ground
    10 kΩ or higher



NG
REPAIR OR REPLACE HARNESS AND CONNECTOR
OK

REPLACE SKID CONTROL ECU