Home › BRAKE › BRAKE CONTROL › ELECTRONICALLY CONTROLLED BRAKE SYSTEM

DTC    C1391/69    Accumulator Leak Malfunction

for Preparation Click here


DESCRIPTION

HINT:
The DTC is stored if a brake fluid, internal or other leak is detected due to improper sealing in the actuator. Internal leakage is suspected if the pump motor operates frequently without braking.


DTC No.
INF Code
DTC Detection Condition
Trouble Area
C1391/69
591
Accumulation performance is deteriorated (improper sealing inside the actuator, gas pressure drop inside the accumulator, leak in each pressure boosting valve).
  1. Fluid leakage
  2. Brake actuator assembly

INSPECTION PROCEDURE

NOTICE:
When replacing the skid control ECU, perform initialization of linear solenoid valve and calibration (Click here).

1.CHECK BRAKE FLUID LEAKAGE
  1. Check that there is no fluid leakage in the brake line between the brake actuator and the wheel cylinder which is the cause of DTCs.

  1. Check that the brake is not dragging.

    OK:
    There is no fluid leakage or dragging.



NG
REPAIR OR REPLACE APPLICABLE PART
OK


2.READ VALUE OF TECHSTREAM (ACCUMULATOR PRESSURE SENSOR)
  1. Check the Data List for proper functioning of the accumulator pressure sensor.

  1. Depress the brake pedal 4 or 5 times to operate the pump motor, and check the output value on Techstream with the motor and check the output value on Techstream with the motor stopped (no braking).

    ABS / VSC / TRAC: 
    Tester Display
    Measurement Item/Range
    Normal Condition
    Diagnostic Note
    Accumulator Sensor 1
    Accumulator pressure sensor 1 / Min.: 0 V, Max.: 5 V
    Specified value: 3.2 to 4.0 V
    -

    OK:
    Accumulator pressure sensor voltage does not drop.



NG
REPLACE BRAKE ACTUATOR ASSEMBLY
OK

REPLACE SKID CONTROL ECU