Home › BRAKE › BRAKE CONTROL › ELECTRONICALLY CONTROLLED BRAKE SYSTEM

ELECTRONICALLY CONTROLLED BRAKE SYSTEM > Brake Control Warning Light Remains ON

for Preparation Click here


DESCRIPTION

The skid control ECU is connected to the combination meter via the CAN and multiplex communications. The brake control warning light illuminates to inform the driver that there is a problem in the Electronically Controlled Brake, or a problem in the brake system that has no influence on driving.

WIRING DIAGRAM


C153501E01


C153494E01


INSPECTION PROCEDURE

NOTICE:
When replacing the skid control ECU, perform initialization of linear solenoid valve and calibration (Click here).

1.CHECK SKID CONTROL ECU (BS1, BS2 VOLTAGE)


    F047485E78
  1. Measure the voltage of the connectors.

    HINT:
    Measure the voltage from behind the connector with the connector connected to the skid control ECU.

    Tester Connection
    Specified Condition
    S7-3 (BS1) - Body ground
    10 to 14 V
    S10-7 (BS2) - Body ground
    10 to 14 V



NG
REPAIR OR REPLACE HARNESS AND CONNECTOR
OK


2.PERFORM ACTIVE TEST BY TECHSTREAM (BRAKE CONTROL WARNING LIGHT)
  1. Select the Active Test, generate a control command, and then check that the brake control warning light operates.

    ABS / VSC / TRAC: 
    Tester Display
    Test Part
    Control Range
    Diagnostic Note
    ECB* Indicator Light
    Brake control warning light
    Warning light ON / OFF
    Observe combination meter
    *: Electronically Controlled Brake

    OK:
    The brake control warning light turns on or off.



NG
REPAIR OR REPLACE COMBINATION METER ASSEMBLY
OK

REPLACE SKID CONTROL ECU