Home › BODY ELECTRICAL › LIGHTING › LIGHTING SYSTEM

LIGHTING SYSTEM > Automatic Light Control Sensor Circuit

for Preparation Click here


DESCRIPTION

The main body ECU receives signals from the automatic light control sensor.

HINT:
A DTC is output when the automatic light control sensor is malfunctioning or there is an open or short circuit in the automatic light control sensor (Click here).


WIRING DIAGRAM


E118453E15


INSPECTION PROCEDURE

1.CHECK BODY ECU
I039976E01
  1. Disconnect the A24 sensor connector.

  1. Measure the voltage of the wire harness side connector.

    Standard voltage:
    Tester Connection
    Condition
    Specified Condition
    1 (CLTB) - 3 (CLTE)
    Power switch ON (IG)
    10 to 14 V



NG
Go to step 4
OK


2.CHECK WIRE HARNESS (ECU - SENSOR)
I102531E01
  1. Disconnect the A24 sensor connector.

  1. Disconnect the B6 ECU connector.

  1. Measure the resistance of the wire harness side connectors.

    Standard resistance:
    Tester Connection
    Specified Condition
    A24-4 (CLTS) - B6-15 (CLTS)
    Below 1 Ω



NG
REPAIR OR REPLACE HARNESS AND CONNECTOR
OK


3.REPLACE AUTOMATIC LIGHT CONTROL SENSOR

OK:
Returns to normal operation.



NG
PROCEED TO NEXT CIRCUIT INSPECTION SHOWN IN PROBLEM SYMPTOMS TABLE
OK

END 

4.CHECK WIRE HARNESS (SENSOR - BODY GROUND)
I039976E03
  1. Disconnect the A24 ECU connector.

  1. Measure the voltage of the wire harness side connector.

    Standard voltage:
    Tester Connection
    Condition
    Specified Condition
    A24-1 (CLTB) - Body ground
    Power switch ON (IG)
    10 to 14 V



NG
Go to step 6
OK


5.CHECK WIRE HARNESS (ECU - SENSOR)
I102531E02
  1. Disconnect the A24 sensor connector.

  1. Disconnect the B6 ECU connector.

  1. Measure the resistance of the wire harness side connectors.

    Standard resistance:
    Tester Connection
    Specified Condition
    A24-3 (CLTE) - B6-14 (CLTE)
    Below 1 Ω



NG
REPAIR OR REPLACE HARNESS AND CONNECTOR
OK

PROCEED TO NEXT CIRCUIT INSPECTION SHOWN IN PROBLEM SYMPTOMS TABLE 

6.CHECK WIRE HARNESS (ECU - SENSOR)
I102531E03
  1. Disconnect the A24 sensor connector.

  1. Disconnect the B6 ECU connector.

  1. Measure the resistance of the wire harness side connectors.

    Standard resistance:
    Tester Connection
    Specified Condition
    A24-1 (CLTB) - B6-16 (CLTB)
    Below 1 Ω



NG
REPAIR OR REPLACE HARNESS AND CONNECTOR
OK

PROCEED TO NEXT CIRCUIT INSPECTION SHOWN IN PROBLEM SYMPTOMS TABLE