Home › BODY ELECTRICAL › DOOR LOCK › SMART KEY SYSTEM

SMART KEY SYSTEM > Key Warning Light does not Come ON

for Preparation Click here


DESCRIPTION

The certification ECU and combination meter communicate through the multiplex communication line (BEAN line). When the combination meter's key warning light does not illuminate / flash as specified (Click here), one of the following is malfunctioning: 1) multiplex communication system, 2) certification ECU, or 3) combination meter.

WIRING DIAGRAM


B128888E01


INSPECTION PROCEDURE

1.CHECK MULTIPLEX COMMUNICATION SYSTEM
  1. Check that the multiplex communication system operates normally.

    OK:
    Multiplex communication system operates normally.



NG
GO TO MULTIPLEX COMMUNICATION SYSTEM
OK


2.CHECK OPERATION OF COMBINATION METER
  1. After replacing the combination meter with a new one, check that the key warning light operates normally.

    OK:
    Key warning light operates normally



NG
REPLACE CERTIFICATION ECU
OK

END