Home › BRAKE › BRAKE CONTROL › ELECTRONICALLY CONTROLLED BRAKE SYSTEM

DTC    C1319/35    SCSS Changeover Solenoid Malfunction

for Preparation Click here


DESCRIPTION

The stroke simulator solenoid (SCSS) generates pedal reactive effort during Electronically Controlled Brake control. If one of the 4 wheels loses brake booster function, the stroke simulator operation is prohibited.

DTC No.
INF Code
DTC Detection Condition
Trouble Area
C1319/35
71
When either condition below is met:
  1. SCSS drive circuit is malfunctioning for 0.05 sec. or more.
  2. Short to +B in SCSS
  1. Stroke simulator
  2. Skid control ECU
  3. Harness and connector
C1319/35
72
Current leaks for 0.05 sec. or more when SCSS is off.
  1. Stroke simulator
  2. Skid control ECU
  3. Harness and connector
C1319/35
73
Open circuit in SCSS continues for 0.05 sec. or more.
  1. Stroke simulator
  2. Skid control ECU
  3. Harness and connector
C1319/35
74
Over current in SCSS continues for 0.05 sec. or more.
  1. Stroke simulator
  2. Skid control ECU
  3. Harness and connector

WIRING DIAGRAM


C153499E01


INSPECTION PROCEDURE

NOTICE:
When replacing the skid control ECU, perform initialization of linear solenoid valve and calibration (Click here).

1.INSPECT BRAKE MASTER STROKE SIMULATOR CYLINDER ASSEMBLY


    C178034E01
  1. Disconnect brake master stroke simulator cylinder connector.

  1. Measure the resistance of the cylinder.

    Standard resistance:
    Tester Connection
    Specified Condition
    B17-1 (BSR) - B17-2 (BCSS)
    22.3 to 38 Ω



NG
REPLACE BRAKE MASTER STROKE SIMULATOR CYLINDER ASSEMBLY
OK


2.CHECK BRAKE MASTER STROKE SIMULATOR CYLINDER ASSEMBLY (BSR VOLTAGE)


    C178034E02
  1. Connect the brake master stroke simulator cylinder connector.

  1. Measure the voltage of the connector.

    HINT:
    Measure the voltage from the behind the connector with the connector connected.

    Standard voltage:
    Tester Connection
    Condition
    Specified Condition
    B17-1 (BSR) - Body ground
    Power switch ON
    (READY)
    10 to 14 V



NG
REPAIR OR REPLACE HARNESS AND CONNECTOR
OK


3.CHECK SKID CONTROL ECU (SCSS VOLTAGE)
  1. Select the Active Test mode on Techstream.

    ABS / VSC / TRAC: 
    Tester Display
    Test Part
    Control Range
    Diagnostic Note
    Stroke Simulator Cut Valve Pattern
    Stroke simulator cut valve pattern activation
    Activation ON / OFF
    Operation of solenoid (clicking sound) can be heard



    F047485E65
  1. Use the Active Test commands shown below to turn the stroke simulator cylinder ON or OFF, and measure the voltage of the SCSS terminal.

    Standard voltage:
    Tester Connection
    Condition
    Specified Condition
    S7-13 (SCSS) - Body ground
    Brake master stroke simulator cylinder
    ON
    Below 1.5 V
    S7-13 (SCSS) - Body ground
    Brake master stroke simulator cylinder
    OFF
    10 to 14 V



NG
REPAIR OR REPLACE HARNESS AND CONNECTOR
OK

REPLACE SKID CONTROL ECU