Home › SUSPENSION & AXLE › SUSPENSION › REAR SHOCK ABSORBER WITH COIL SPRING

REAR SHOCK ABSORBER WITH COIL SPRING > INSTALLATION

for Preparation Click here



1. INSTALL REAR SHOCK ABSORBER WITH COIL SPRING


    C067565E01
  1. Install the rear shock absorber with coil spring to the rear axle beam. Place the spacer and temporarily tighten the nut.

  1. Install the rear shock absorber with coil spring (upper side) to the vehicle by slowly raising the rear axle beam on a jack. Insert a wooden block between the jack and the rear axle beam to prevent damage.

    NOTICE:
    1. Do not raise the rear axle beam more than necessary.
    2. Securely insert the rear spring front bracket stud bolt into the vehicle.



    G027360E01
  1. Tighten the bolt and 2 nuts of the rear shock absorber with coil spring (upper side).

    Torque:
    80 N*m{ 816 kgf*cm , 59 ft.*lbf }



2. INSTALL REAR WHEEL
  1. Install the rear wheel.

    Torque:
    103 N*m{ 1,050 kgf*cm , 76 ft.*lbf }



3. STABILIZE SUSPENSION
  1. After lowering the vehicle, bounce the vehicle up and down to stabilize the rear suspension.



4. FULLY TIGHTEN REAR SHOCK ABSORBER WITH COIL SPRING


    C067565E01
  1. Tighten the rear shock absorber with coil spring (lower side) installation nut.

    Torque:
    80 N*m{ 816 kgf*cm , 59 ft.*lbf }

    NOTICE:
    Ensure the vehicle is lowered to the ground.



5. INSTALL BATTERY CARRIER BRACKET


    A083527E01
  1. Install the battery carrier bracket with the 7 bolts.

    Torque:
    28 N*m{ 286 kgf*cm , 21 in.*lbf }



6. INSTALL DECK TRIM SIDE PANEL ASSEMBLY LH


    B073591E02
  1. Attach the 7 claws and 3 clips to install the side panel.

  1. Install the clip, screw and 2 bolts.



7. INSTALL DECK FLOOR BOX LH


8. INSTALL REAR NO. 4 FLOOR BOARD


9. INSTALL REAR SIDE SEATBACK FRAME LH


    B132620
  1. Attach the claw to install the frame.

  1. Install the bolt.



10. INSTALL REAR NO. 1 FLOOR BOARD


    B132619E01
  1. Attach the 5 clips to install the floor board.

  1. Install the 2 clips, 2 bolts and 2 rope hooks.



11. INSTALL REAR SEATBACK ASSEMBLY LH
  1. Install the side seatback with the bolt.



12. INSTALL TONNEAU COVER ASSEMBLY


13. INSTALL REAR DECK TRIM COVER


    B076395E02
  1. Attach the 4 claws to install the trim cover.



14. INSTALL REAR DECK FLOOR BOX


15. INSTALL REAR NO. 2 FLOOR BOARD


16. INSPECT REAR WHEEL ALIGNMENT
  1. Inspect the rear wheel alignment (Click here).



17. PERFORM INITIALIZATION
  1. Perform the initialization (Click here).

    NOTICE:
    Certain systems need to be initialized after disconnecting and reconnecting the cable from the negative (-) battery terminal.