Home › SUSPENSION & AXLE › SUSPENSION › REAR WHEEL ALIGNMENT

REAR WHEEL ALIGNMENT > INSPECTION

for Preparation Click here



1. INSPECT TIRE
  1. Inspect the tires (Click here).



2. MEASURE VEHICLE HEIGHT
  1. Measure the vehicle height (Click here).



3. INSPECT TOE-IN


SA03213E02

Standard toe-in:
Item
Specified Condition
Toe-in
(total)
A + B: 0° 18' +-15' (0.30° +-0.25°)
C - D: 3.0 +-2.5 mm (0.12 +-0.10 in.)

HINT:
  1. Measure "C - D" only when "A + B'" cannot be measured.
  2. If the toe-in is not within the specified range, inspect the suspension parts for damage and/or wear, and replace them if necessary.



4. INSPECT CAMBER
  1. Install the camber-caster-kingpin gauge or set the vehicle on a wheel alignment tester.

  1. Inspect the camber.

    Standard camber:
    Item
    Specified Condition
    Camber
    Right-left error
    -1° 30' +-30' (-1.50 +-0.5°)
    30' (0.5°) or less

    HINT:
    Camber is not adjustable. If the measurement is not within the specified range, inspect the suspension parts for damage and/or wear, and replace them if necessary.