Home › BRAKE › BRAKE › BRAKE MASTER CYLINDER

BRAKE MASTER CYLINDER > REMOVAL

for Preparation Click here



1. REMOVE WINDSHIELD WIPER MOTOR AND LINK ASSEMBLY
  1. Remove the windshield wiper motor and link (Click here).

    HINT:
    Refer to the procedures from the removal of the front wiper arm LH/RH up until the removal of the windshield wiper motor and link assembly.



2. SET BRAKE CONTROL OFF


F046145E01

NOTICE:
Prohibit the brake control (Electronically Controlled Brake system) before bleeding the brake fluid.

  1. With the power switch OFF to prohibit brake control, remove the No. 1 and No. 2 motor relays.

    NOTICE:
    If the pump motor operates while there is air remaining inside the brake actuator hose, the air will enter the actuator, resulting in difficulty in air bleeding.

    HINT:
    Brake control (Electronically Controlled Brake system) can be prohibited by selecting "ELECTRONICALLY CONTROLLED BRAKE SYSTEM INVALID" on the Techstream.



3. REMOVE OUTER FRONT COWL TOP PANEL SUB-ASSEMBLY


    F046090E01
  1. Remove the 2 bolts and engine room No. 2 R/B.



    F046146E01
  1. Remove the 3 clamps from the outer front cowl top panel.



    F046147E01
  1. Remove the 7 bolts and outer front cowl top panel.



4. REMOVE INVERTER WITH CONVERTER
  1. Remove the inverter with converter (Click here).

    HINT:
    Refer to the procedures from the removal of the engine under cover LH up until the removal of the inverter with converter.



5. DRAIN BRAKE FLUID

NOTICE:
Wash brake fluid off immediately if it adheres to any painted surface.



6. REMOVE NO. 1 INSTRUMENT PANEL REGISTER ASSEMBLY


B074044E02
  1. Detach the 2 claws and 4 clips, and remove the instrument panel register.



7. REMOVE LOWER INSTRUMENT PANEL FINISH PANEL SUB-ASSEMBLY


B074045E02
  1. Remove the 2 screws.

  1. Disconnect the hood lock control cable.

  1. Detach the 4 claws and 5 clips.

  1. Disconnect all connectors and remove the instrument panel finish panel.



8. REMOVE BRAKE MASTER CYLINDER SUB-ASSEMBLY


    F046148E01
  1. Remove the brake return spring.

  1. Remove the clip and brake master cylinder push rod pin, and disconnect the push rod clevis from the brake pedal.



    F046149E01
  1. Remove the 4 clips and 2 reservoir tube hoses.



    F046150E01
  1. Remove the bolt from the actuator bracket.

  1. Using SST, remove the No. 1 front brake tube.

    SST
    09023-00101  



    F046151E01
  1. Using SST, disconnect the No. 2 front brake tube from the clamp and brake master cylinder.

    SST
    09023-00101  



    F046152E01
  1. Remove the 2 nuts, brake master cylinder gasket and brake master cylinder from the bracket.



    F046154E01
  1. Using SST, remove the brake tube and 2-way from the brake master cylinder.

    SST
    09023-00101  



    F101067
  1. Remove the screw, No. 1 brake master cylinder union and 2 grommets from the brake master cylinder.



    F101055
  1. Loosen the clevis lock nut and remove the brake master cylinder push rod clevis.