BRAKE MASTER CYLINDER > ON-VEHICLE INSPECTION |
| 1. INSPECT BRAKE MASTER CYLINDER |
Check battery voltage.
Connect the Techstream and pedal effort gauge.
Connect the pedal effort gauge.
Move the shift lever to the P position. Apply the parking brake and connect the Techstream to the DLC3.
Turn the power switch ON (IG).
Clear the DTC (Click here).
Check operation w/o brake booster.
Check and adjust brake pedal height .
Check pedal free play .
Check pedal reserve distance .
Turn on the Techstream and enter the following menus: Chassis / ABS/VSC/TRAC / Utility / Electronically Controlled Brake system Utility / Electronically Controlled Brake system Invalid to prohibit the brake control.
Enter the following menus: Chassis / ABS/VSC/TRAC / Data List "Master Cylinder Sensor", "Master Cylinder Sensor 2", "Stroke Sensor" and "Stroke Sensor 2".
Check the value output from "Master Cylinder Sensor", "Master Cylinder Sensor 2", "Stroke Sensor" and "Stroke Sensor 2" by depressing the brake pedal.
| Pedal Effort N (kgf, lbf) | Master Cylinder Sensor (V) | Master Cylinder Sensor 2 (V) | Stroke Sensor (V) | Stroke Sensor 2 (V) |
| 200 (20.4, 45) | 0.9 to 1.2 | 0.9 to 1.2 | 1.7 to 2.1 | 2.9 to 3.3 |
| 500 (51, 112) | 1.7 to 2.2 | 1.7 to 2.2 | 1.9 to 2.3 | 2.7 to 3.1 |
Finish the brake control prohibition on the Techstream.