Home › BRAKE › BRAKE › BRAKE STROKE SIMULATOR CYLINDER

BRAKE STROKE SIMULATOR CYLINDER > REMOVAL

for Preparation Click here



1. REMOVE WINDSHIELD WIPER MOTOR AND LINK ASSEMBLY
  1. Remove the windshield wiper motor and link (Click here).

    HINT:
    Refer to the procedures from the removal of the front wiper arm LH/RH up until the removal of the windshield wiper motor and link assembly.



2. SET BRAKE CONTROL OFF


F046145E01

NOTICE:
Prohibit the brake control (Electronically Controlled Brake system) before bleeding the brake fluid.

  1. With the power switch OFF to prohibit brake control, remove the No. 1 and No. 2 motor relays.

    NOTICE:
    If the pump motor operates while there is air remaining inside the brake actuator hose, the air will enter the actuator, resulting in difficulty in air bleeding.

    HINT:
    Brake control (Electronically Controlled Brake system) can be prohibited by selecting "ELECTRONICALLY CONTROLLED BRAKE SYSTEM INVALID" on the Techstream.



3. REMOVE OUTER FRONT COWL TOP PANEL SUB-ASSEMBLY


    F046090E01
  1. Remove the 2 bolts and engine room No. 2 R/B.



    F046146E01
  1. Remove the 3 clamps from the outer front cowl top panel.



    F046147E01
  1. Remove the 7 bolts and outer front cowl top panel.



4. DRAIN BRAKE FLUID

NOTICE:
Wash brake fluid off immediately if it adheres to any painted surface.



5. REMOVE BRAKE STROKE SIMULATOR CYLINDER SUB-ASSEMBLY


    F046158E01
  1. Using SST, disconnect the 2 brake tubes from the brake simulator cylinder.

    SST
    09023-00101  

  1. Disconnect the connector.



    F046159E01
  1. Remove the 2 nuts, 2 bolts and brake stroke simulator cylinder with bracket.



    F101068
  1. Remove the 2 bolts, connector clamp and bracket from the brake stroke simulator cylinder.

  1. Remove the 2 stud bolts from the brake stroke simulator cylinder.