FRONT BRAKE > REASSEMBLY |
| 1. INSTALL FRONT DISC |
Align matchmarks on the disc and the axle hub. Install the front disc.
| 2. INSPECT DISC RUNOUT |
![]() |
Check the looseness of the front wheel bearing and runout in the axle hub before inspecting the disc runout (Click here).
Hold the front disc with the 3 hub nuts.
Holding a dial indicator 10 mm (0.394 in.) away from the outer edge of the front disc, measure the disc runout.
| 3. TEMPORARILY TIGHTEN FRONT DISC BRAKE BLEEDER PLUG |
| 4. INSTALL FRONT DISC BRAKE BLEEDER PLUG CAP |
| 5. INSTALL PISTON SEAL |
Apply lithium soap base glycol grease around a new piston seal and install it into the brake cylinder groove securely.
| 6. INSTALL FRONT DISC BRAKE PISTON |
![]() |
Check the side of the front disc brake piston for any scratch.
Apply lithium soap base glycol grease to the inside of a new cylinder boot and install it to the front disc brake piston.
Apply lithium soap base glycol grease around the front disc brake piston and install it to the front disc brake cylinder.
| 7. INSTALL CYLINDER BOOT |
![]() |
Install the cylinder boot to the disc brake cylinder groove.
Using a screwdriver, install a new front disc brake piston set ring to the front disc brake cylinder.