Home › BRAKE › BRAKE CONTROL › FRONT SPEED SENSOR

FRONT SPEED SENSOR > INSTALLATION

for Preparation Click here



1. INSTALL FRONT SPEED SENSOR

NOTICE:
  1. Do not twist the sensor wire harness during installation.
  2. Check that there is no foreign matter attached to the tip and connecting portion of the speed sensor.

  1. Clean the connecting portion of the sensor.



    F047471E01
  1. Install the sensor with the bolt.

    Torque:
    8.0 N*m{ 82 kgf*cm , 71 in.*lbf }

  1. Install the clip to the front shock absorber.



    F046179E02
  1. Install the sensor clamps to the body and front shock absorber with the bolts A and B.

    Torque:
    8.0 N*m{ 82 kgf*cm , 71 in.*lbf } for bolt A
    19 N*m{ 192 kgf*cm , 14 ft.*lbf } for bolt B

    NOTICE:
    Tighten the bolt B together with the brake flexible hose clamp and sensor clamp. The brake flexible hose clamp should be placed above.



    F046175E01
  1. Connect the sensor connector.



2. INSTALL FRONT FENDER LINER


3. INSTALL FRONT WHEEL

Torque:
103 N*m{ 1,050 kgf*cm , 76 ft.*lbf }



4. CHECK ABS SPEED SENSOR SIGNAL
  1. Check the speed sensor signal (Click here).