Home › BRAKE › BRAKE CONTROL › SKID CONTROL ECU

SKID CONTROL ECU > REMOVAL

for Preparation Click here



1. DISCONNECT CABLE FROM NEGATIVE BATTERY TERMINAL

CAUTION:
Wait at least 90 seconds after disconnecting the cable from the negative (-) battery terminal to prevent airbag and seat belt pretensioner activation.

NOTICE:
When disconnecting the cable, some systems need to be initialized after the cable is reconnected (Click here).



2. REMOVE STEERING COLUMN ASSEMBLY
  1. Remove the steering column (Click here).

    HINT:
    Refer to the procedures from the removal of the No 2. rear floor board up until the removal of the steering column assembly.



3. REMOVE SKID CONTROL ECU
  1. Remove the wire harness clamp and skid control buzzer from the skid control ECU bracket.



    C127949
  1. Disconnect the 4 skid control ECU connectors.

  1. Remove the 3 nuts and skid control ECU.