Home › BRAKE › BRAKE CONTROL › BRAKE CONTROL POWER SUPPLY

BRAKE CONTROL POWER SUPPLY > REMOVAL

for Preparation Click here



1. REMOVE REAR SEAT CUSHION ASSEMBLY


    B132600E01
  1. Detach the seat cushion's 2 front hooks from the vehicle body.

    NOTICE:
    Follow the instructions below carefully as the cushion frame deforms easily.


    1. Choose a hook to detach first. Place your hands near the hook as shown in the illustration. Then lift the seat cushion to detach the hook.

    2. Repeat for the other hook.

  1. Detach the seat cushion's rear hook.

  1. Remove the seat cushion.



2. REMOVE DECK TRIM SIDE PANEL ASSEMBLY RH
  1. Remove the deck trim side panel RH (Click here).

    HINT:
    Refer to the procedures from the removal of the rear door scuff plate RH up until the removal of the deck trim side panel assembly RH.



3. REMOVE BRAKE CONTROL POWER SUPPLY ASSEMBLY


    C127951
  1. Disconnect the connector.

  1. Remove the 4 bolts and brake control power supply.



4. REMOVE NO. 3 BRAKE CONTROL POWER SUPPLY BRACKET


5. REMOVE NO. 2 BRAKE CONTROL POWER SUPPLY BRACKET


6. REMOVE NO. 1 BRAKE CONTROL POWER SUPPLY BRACKET