Home › BRAKE › BRAKE CONTROL › STEERING ANGLE SENSOR

STEERING ANGLE SENSOR > INSTALLATION

for Preparation Click here



1. INSTALL STEERING ANGLE SENSOR


    F045898E03
  1. Align the locating pins, attach the 6 claws and install the sensor to the spiral cable.



2. INSPECT SPIRAL CABLE SUB-ASSEMBLY
  1. Check that there are no scratches or cracks on its connector, and that the cable does not have cracks, dents or chipping.



3. INSTALL SPIRAL CABLE SUB-ASSEMBLY
  1. Check that the front wheels are facing straight ahead.

  1. Set the turn signal switch to the neutral position.

    NOTICE:
    Make sure that the turn signal switch is in the neutral position, as the pin of the turn signal switch may be snapped.

  1. Install the spiral cable.

    NOTICE:
    When replacing the spiral cable with a new one, remove the lock pin before installing the steering wheel.

  1. Connect the connector to the spiral cable.

    NOTICE:
    When handling the airbag connector, do not damage the airbag wire harness.



4. INSTALL STEERING COLUMN COVER
  1. Engage the 4 claws to install the steering column upper cover and steering column lower cover.

    HINT:
    Fully tilt down the steering column when installing the steering column upper cover and fully tilt it up when installing the steering column cover.



5. POSITION SPIRAL CABLE


H043750E02
  1. Slowly rotate the spiral cable counterclockwise by hand until it feels firm.

    NOTICE:
    Do not use the airbag wire harness to turn the spiral cable.



    H043751E02
  1. Rotate the spiral cable clockwise approximately 2.5 turns to align the marks.

    NOTICE:
    Do not use the airbag wire harness to turn the spiral cable.

    HINT:
    The spiral cable will rotate approximately 2.5 turns to the left and right from the center.



6. INSTALL TILT LEVER BRACKET
  1. Install the tilt level bracket with the 2 screws.

    Torque:
    2.0 N*m{ 20 kgf*cm , 18 in.*lbf }



7. INSPECT STEERING WHEEL CENTER POINT

HINT:
When the steering wheel is not properly centered, remove and refit to center.



8. INSTALL STEERING WHEEL ASSEMBLY
  1. Align the matchmarks on the steering wheel and steering main shaft.

  1. Install the steering wheel with the set nut.

    Torque:
    50 N*m{ 510 kgf*cm , 37 ft.*lbf }



9. INSTALL STEERING PAD ASSEMBLY


H043738E03
  1. Support the steering pad with one hand as shown in the illustration.

  1. Connect the 2 airbag connectors.

    NOTICE:
    When handling the airbag connector, do not damage the airbag wire harness.

  1. Connect the horn connector.

  1. Install the steering pad after confirming that the circumference grooves of the screws are caught on the screw case.

  1. Using a T30 "TORX" socket, install the 2 screws.

    Torque:
    8.8 N*m{ 90 kgf*cm , 78 in.*lbf }



10. INSPECT STEERING PAD ASSEMBLY
  1. Inspect the steering pad (Click here).



11. CONNECT CABLE TO NEGATIVE BATTERY TERMINAL

NOTICE:
When disconnecting the cable, some systems need to be initialized after the cable is reconnected (Click here).



12. CHECK SRS WARNING LIGHT
  1. Check the SRS warning light (Click here).