Home › BODY › WINDSHIELD / WINDOWGLASS › POWER WINDOW CONTROL SYSTEM

POWER WINDOW CONTROL SYSTEM > Auto Up Operation does not Fully Close Power Window (Jam Protection Function is Activated)

for Preparation Click here


DESCRIPTION

If the door glass or the power window regulator motor does not operate smoothly, the jam protection function may trigger automatically, resulting in the AUTO UP function being unable to fully close the window.

HINT:
The jam protection function is only available on the driver side power window.


WIRING DIAGRAM


E124627E01


INSPECTION PROCEDURE

1.RESET POWER WINDOW REGULATOR MOTOR FRONT LH
  1. Reset the power window regulator motor (Click here).

  1. Check that the power window AUTO UP / DOWN function operates normally.

    OK:
    AUTO UP / DOWN function operates normally.



OK
END
NG


2.CHECK POWER WINDOW REGULATOR ASSEMBLY LH
  1. Remove the door glass (Click here).

  1. Operate the front door window regulator using the switch.

  1. Check that the power window regulator operates smoothly.

    OK:
    Power window regulator operates smoothly.



NG
REPLACE POWER WINDOW REGULATOR ASSEMBLY LH
OK

REPLACE DOOR GLASS RUN